The Jalopy Journal
Thanks guys, that's what I needed to know. The remote 1217 a/c condenser that Southern Street Rods sells looks like the one to use.
Curious if anyone has ever used a fan powered trans cooler as a a/c condenser. Since most of the trans coolers I've seen are so much smaller than...
Thanks guys, the photos really help. Jim
Can I get a side shot on the mount? Thanks, Jim
Yeah, I saw the misalignment on the shocks, that's the way I got the car. I have figure out how to fix it without ruining the powder coat. May...
[ATTACH] [ATTACH] Here are frame horn photos showing the shock mounts
Could I see photos of the headlight stands mounting position on 32 Ford 3 window? Also trying to determine which stands to use. The frame is boxed...
Thanks everyone. With your help I got them installed. Jim
No problem. I didn't have any idea how to install the rods, had never seen them before, at least now I have something to go by. Thank You!
Thanks, BJR -- that gives me an idea of where to put them. Jim
What I need to know is the exact placement of the radiator support rods on the firewall and also on the radiator. There's a bracket on my...
Didn't see the link, but I just read online how to do it, and I even have an inch pound beam torque wrench. But, I paid them to check it out, and...
OK, Thanks. I took the trans to the shop to have it checked out, they pulled the pump, pan etc. and it checked out good but after getting it back...
There's a 9/16 nut with an allen head bolt next to the shift lever on my Powerglide, what is this for?[ATTACH]
RushNoMore, the builder of my 32 put the rear housing together, the axles, bearings, spacer and flanges were already installed along with the disc...
Thanks, Jim This is all new to me.
New Lubelocker gasket came, I installed the Lubelocker gasket, snugged and torqued the locknuts with a new set of copper washers added 1 1/2...
Decided to try a Lubelocker gasket, even though I got the FelPro in today. They claim no sealer is needed. Hope it's OK to use on bare metal.
The new gasket came today, and it's the correct one, all the holes line up. I stripped the powder coating off the housing, and am now looking at...
Thanks to everyone that responded to my problem. I now have several options. Jim
I've been rethinking installation of the paper gasket, and I seem to remember that the holes for the bottom studs were a little bit off. I thought...
Finally got a good used posi 3:70 third member for the 9" in my 32. Bought a FelPro gasket for it, put yellow glue on the housing and also on the...
OK, here's what we found. The input shaft wasn't fully seated, that's why the converter wouldn't go all the way in. It is all the way in now....
No, they're in Aston, PA -- I'm in Central Texas
Thank you! From what I learned from the video I have a combo shaft that's 12 3/4" long, and that seems to be the shortest one out there. This all...
Here's where we are. Pulled the pump (didn't take it apart) and the tangs are correct. Slid the converter on the pump without the input shaft, and...
Transmission Specialties supplied the input shaft so a turbo 350 converter can be used. It's a 30 spline unit and the torque converter is also 30...
OK, I had a situation happen like this once before, where there were 2 tabs to engage a part; and one was installed correctly, the other wasn't....
If the tabs are installed incorrectly, how do you fix it? Pull the pump cover and flip the pump gear where they are turned the right way? Thanks
Separate names with a comma.
The Jalopy Journal
