The Jalopy Journal
It was mid 70's. I'm at a gas station in Miami, A kid(a few years younger than me) pulls in in a model a coupe. I was blown away: hadnt seen one...
I received # 86 in mail yesterday. I'm going to extend my subscription for 2 years to inject some needed capital into the business. It's a great...
' Car is SOLD [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
The early Bronco is 58" wheel mounting surface to wheel mounting surface. The 57-59 ford rear end is 57.25 WMS to WMS . The Bronco has 5 on 5 1/2...
Love this show. I go every year. It's about an hour and a half from my place. That deuce 5w in red primer is cool; wonder what became of it?...
Feb 7th 2003
If they have GT cast into them they are GT40 irons. I have them on a '96 Explorer motor. After that they went to the GT40P heads, which have...
United Pacific. Not cheap but of good quality.
Issue # 85 now in my sweaty grease laden hands. Will miracles ever cease
Thanks again ,Baron. I'll try shimming the box out with washers or a spacers first, then as a last resort , weld on a fabricated flange at an...
Thanks, Baron. I could use that measurement. Don't know why I'm even worried about having the exact location as I'm limited by my header...
Baron, What did you do about the F100 steering box flange to make it work in the deuce frame ? I know there's several different methods. Just...
Around 1977-78 I had a '54 mercury monterey. I ruined the hood but luckily found a'53 hood to replace it. As I remember it was a direct bolt on....
bump
$125 + shipping Anyone need brakes for their hot rod ?
reduced to $145 I priced these low to offset shipping cost
1932 Ford drip rails good for 5w, tudor, fordor, etc. I used a small piece off each length, but still long enough for most cars. One is 71",one...
[ATTACH] White 13" steering wheel. Same as the metal flake wheels only in white. Comes with parts shown in photo. Not perfect but fairly nice...
'53-'56 Ford F100 front brakes set up for 37-41 spindles ( inner bearing race has been clearanced) or get new new inner bearing ,then use for...
This is a '32 commercial grille that has been chopped 4" . A' 34 style trim ring has been added It has several layers of paint, but appears they...
proprtions look best between 3" and 4" chop , IMHO
On my 32 5w there is considerably less wind noise with the windshield open. It was a lot quieter before I chopped it because the windshield...
Mine are Coker Firestones, albeit blackwalls . They are perfect, though. They balanced fine and are very smooth at all speeds. I do have pristine...
I tried to go last year ,but couldn.t get across the Bay bridge. I've been many times in 3 different locations over the years. It's a pleasure to...
I'll be in the blue field VB041 only on Saturday. I've got a bunch of HAMB friendly stuff I dont need, so hopefully it will find a new home.
I made a set out of plywood for my Deuce 5w ,but they squeaked terribly. No matter what I did i couldnt get them to stop. Then I bought a steel...
Steve, I have a ford 3/4" shaft which i believe is 40 spline and threaded with a nut for steering wheel approx 31.25 " in length IIRC it was...
test[ATTACH]
test[ATTACH] [ATTACH]
Separate names with a comma.
The Jalopy Journal
