The Jalopy Journal
Painted front end, rubber. Chrome everything (not hamb friendly) stainless braided.
Parallel spring will bind with trianguled 4 bar. Could maybe do 4 bar setup with parallel spring, still might bind. Most 4 bar setups have...
..
What is the web site you posted @2 weeks ago with all the car and truck dimensions on it? Thanks, Bob
Don't have any pics of it, but look at a 1970-1980 maybe a little newer Dodge van with power brake setup. They have a 90 degree pedal bracket that...
402Bossman, this price came from Car Quest, west O street, Lincoln.
What are you guys paying for machine work on engine block? In Lincoln NE. Clean and magnaflux block, magnaflux turn and polish crank, R & R cam...
Old Mopars are good looking cars, look like a great car to start with. Will be watching this one. BOB
So how can this be? #1 TDC is still in the same place on rotation of the crank, if marks just moved timming light would no flash with marks.
SBC harmonic balancer comes with timing mark in 4 different locations using different timing tabs. Did the keyway in the crank move also or not?...
[ATTACH] Not hamb friendly bbut here is my Chevy Coupe. Still on a wood structure.
Thanks guys, I will see how long the Mr Gasket pump lasts. They are replacing the Airtex pump under warranty so will have it laying around. Big Bob
There is a filter before pump, It is 6 inches away from exhaust pipe at rear of car. My airtex lasted 17 months, they are replacing pump under...
I have an elec fuel pump next to the tank in my 39 Plymouth. In the last 15 years, maybe 25,000 miles I have gone through 5 pumps, the first...
Here's one, car belongs to my cousin, has a 351 out of a Lincoln in it. Car was purchased new by our grandparents.[ATTACH]
Probably not the problem, but 7 lbs cap seams low. Maybe a 14lbs. This would raise the boiling point of coolent.
You need a 350 with a 9 inch tail shaft housing, the trans mount will be forward 3/4 of an inch.
Btt
Use GM front calipers, they will work in the brackets you have and then get an E-brake kit that goes on the pinion of your 9 inch rear end.
Watt's auto salvage, Wymore NE has a lot of old stuff. Give them a try.
2. Ea. Adapters.[ATTACH][ATTACH]
Rock auto has .030 pistons. 32 bucks each for the 292
U joints or bent drive shaft
Use copper line for this application, new ferral. When useing plastic line in a compression fitting there is a small piece of brass that...
Maybe this will help.[ATTACH]
Talking to an old timer today, asked about these O stamped valve covers. He said there were triangle stamped and O stamped rockers, the O stamped...
Ok guys, I have searched the old posts and cant seem to find what I need. Using an internally regulated 3 wire alt as a 1 wire. It drains the...
Check timming with light, put coolent recovery tank on it, air in system is bad. Put 16 lb cap on it. Each lb in cap rating changes boiling...
Epoxy primer on bare metal, spread your bondo, take 80 grit and remove some bondo to get general shape before it completely hardens up.
If you go with an electric fan surplus center has fans that are supposed to be used on Ferrari cars, dont know if they are Spal. 16 inch puller,...
Separate names with a comma.
The Jalopy Journal
