The Jalopy Journal
Throw out bearing should just clear the three studs at rest.
"just get the valve opened to maximum lift, and then rotate the crankshaft exactly one turn. The lifter for that valve is now on the heel of the...
Why does one need this?
Is your 21 stud babbitt or insert mains?
Both the spindle bushing bores and axle bores need to be a snug slip fit.
Take Grumpys advise and go with the old stuff; much better deal and the right way also! Really cool A. Good luck.....Will
3 port on Ebay 201957882019
Thanks; I tried 8mm VW valves for stem fit, but exhaust guides still loose.
What is the group consensus, (pros and cons), of running the side covers on the '28 engine? Covers would hinder cooling of the right side block...
Six Ball; thanks so much for the good pictures of the Durant rods. I am looking for a set of these and had found the ones on ebay; was about to...
"T Has anyone tried using a "T" Ford piston; 3 3/4" std. bore, so cylinders would need to be bored .0625, just right for a clean-up. I need to...
Herb; I'm a long time fan of the early Chevy four. Reading over this thread for the last few days, I recall you referring to A Ford rods modified...
Separate names with a comma.
The Jalopy Journal