The Jalopy Journal
Aright guys I think I've got it with your help of course I put two ten inch puller fans on engine side of radiator and installed 17 or 16" fan on...
Big Duece I'm glad you liked the video it has been very helpful to me if I play it on my flat screen tv I can see all the gauge values while...
Wow I just got a look at all the replies thanks for all the feedback having a group give you that much advice is great! I will take it all in and...
Thanks for input I'll try it tomorrow
Dana, The pump I have puts out 55gpm static and runs around 35gpm though the block the factory pumps around 18 to 20 I had to run a restrictor...
Willy, I used hand held pyrometer to check gauge and it is high but readings that I posted are from meter. I ran pushers first without puller and...
Hello, I need help with over heating problem I have a 468 bbc with 8.9 cr with a 871 blower with 15% under drive I'm running a electric water pump...
Hello: I have a doug nash in my old drag car it's a crash box done by liberty and is always noisy but 3rd and 4th seem to be louder than 1st and...
Hello: I just scatterd my 427 built using a 454 block and a 396 crank. Now I have to put another motor together in the next week what I have in...
I'll set timing down tomorrow thanks
thanks for your input if you are wondering why I bought a stripped blower it had just been rebuilt at dyers and the peice was right if I wear it...
Just ran a psi gauge on it when in burn out went about 6500 rpm made about 6psi will call shop tomorrow ask about carb just had that one on shelf...
To finish question just trying to see what horsepower gain might be. As far as stripped blower on street its about 6 miles to cruise and take 3...
Rear gear is 433 tire diameter is 32.5
Cam is 708/680 262/252 at 50 112 center carb has not been setup for blower yet springs are for 800 lift heads are dart 308 runners pistons are...
just wanted recomended underdrive ratio
Sorry for the lack of info but it got it started. Blower is teflon stripped I have a 1000cfm b/g carb on it and I haven't had it down track yet...
Hello: This is Gasserman needing your help again. So I built this really neeto old 63 corvette gasser that has allot of history and it is pretty...
Have not found much either would like to know more have tried calling with no luck. was going to email but they did not seem to have email...
Thanks for the response sounds like a great track and I've seen the videos of the june meet and it looks like a very good time. And to answer the...
Does anybody know how good the September gasser nationals at thompson racway are. I have a six hour drive and I want to make sure it's a good...
Hello: my name is Ed screen name is Gassermann i have nostalgic gasser called orange peel it is a 1963 corvette that has been a race car since...
Hello: I have a 1963 corvette gasser i put restored for nostalgia drag racing neet car took alot of work. It's built all old school but my edrele...
Separate names with a comma.
The Jalopy Journal