The Jalopy Journal
Speaking of pickup trucks, mattresses, and morgan freeman, i vividly remember a very good night with a gal ( now my wife) at the drive in...
Recently purchased a 58 nomad, starting to gather the parts to get her running... yes its a more door, but with kids that's a good thing ( think...
Been a few years, but i think WZ Junk is right, not attached at top and 1 fastener at the bottom. I installed some reproductions (possibly from...
Usually go with the tried and true ball pein. When I was a kid, my folks were dead broke and Dad taught me how to make a gasket for the...
Its got rust in the passenger floor pans, several random small rust spots, and a line of rust bubbles on the bottom of the tail gate, but not bad...
I jacked up each wheel while it was on trailer. Front passenger spun freely, driver front had quite a bit of drag, both rears had alot of drag...
I crawled under and there doesnt seem to be any tension on the cables... will jack up one wheel at a time and see if problem is localized to one...
Well, went out and got a new project (58 Nomad), but in all the excitement I made a rookie mistake... Yup, When we got the car on the trailer and...
How did you get out of that situation? And how long did you own that vehicle afterwards? Sent from my SAMSUNG-SM-N900A using The H.A.M.B. mobile app
Got anything in Tall sizes? Nobody enjoys butt cleavage unless its accompanied by a thong...
Good save! Students? Sent from my SAMSUNG-SM-N900A using The H.A.M.B. mobile app
32 now, started on the old cars when i was 23. I always hear about of talk about the future of the classic car hobby and how my generation is...
"On models with poerglude transmission, remove the second cylinder head bolt from the rear on the left side and the fourth bolt from the rear on...
if you hook your lift chain up to the wrong head bolts it will change the balance of the engine and you will hang up on the cross member or...
Note the picture of my 235 above, it's a full pressure with hydraulic lifters, and it has the two studs on the valve cover... the studs aren't...
How does she run? I rebuilt a 54 235 with hydraulic and put it in my 53 and have been very happy. bored .08 over has plenty of power for freeway...
Most of these cars have had an engine swap at some point, so the best way to tell it's to use the casting numbers from the block (located by the...
I've rebuilt many Rochester BC's... Most of the time the cause of leaks is the gasket between the fuel bowl and air horn (the two main aluminum...
So a couple years ago I was getting into the electrolysis thing, using washing soda as my main brine.... Worked well... Anyhow one of the older...
So im the owner of a 53 & 54 belair, that are in very stages of restoration... I read tons of post on here, and was thinkin it might be time to...
Separate names with a comma.
The Jalopy Journal