The Jalopy Journal
Pictures would be helpful.
Is this a channeled body or Highboy?
I've been following your build, what a great job. As far as pinstripes, the red would stick out and clash too much. I would leave it as is or go...
The original SW electric wings gauges have specific senders that will work only with a particular gauge. I do not no of any interchanges between...
Always an impressive show. I was disappointed show ends at 4:00, everyone packs up and heads out at 1:30 and they still charge you $10.00 to get...
A couple of shots of a Sprint car. [ATTACH] [ATTACH] [ATTACH]
[ATTACH] [ATTACH] [ATTACH]
Robert I'm sorry we didn't bump into each other. I would have liked to say hello. I did see your dad vending and chatted a little. The event keeps...
[ATTACH] [ATTACH]
For the smaller wiring tubing you could use something like this from Denis Carpenter [ATTACH]
Sounds like your mind is made up. What I was told by a friend in the MVD, some night you maybe screwing around and get pulled over. An astute...
I would suggest taking the blower apart and checking it out. They are fairly simple and replacement bearings are available, but you can screw it...
There's a lot of factors you need to consider. maybe I missed it, what car is this going into? Are you using the 8ba you purchased? Are you going...
Guilty, I installed a 12volt piezo buzzer on my 6 volt system works fine. Actually to loud, had to but a piece of tape over it. Here's one on...
Worm gears clamps IMO clamp down the tightest. The OP wanted period correct, if you have proper size hoses towers should work fine. I have owned...
Speaking in terms of Corvettes of that era. Upper and lower rad hoses were secured with tower clamps. If you want to get crazy, Wittek tower...
Don't be a hater.[ATTACH]
For your consideration. Here's some info from The late "Rumbleseat", aka Paul Garrigan. He ran a 9" clutch with heavier pressure plate springs in...
I converted to Pertronix with the two piece cap. I did need to drill the openings for the 8mm radio suppression wires. Here's from the barn on...
Nicely done!
Friday had a good turn out, I enjoyed it. Reacquainted with some old friends. Looks like the rain held off for Saturday for the events. Thanks...
I grew up in Windham and was just there for the 4th of July. The Hamilton Motel was just renovated, not sure if it's open yet. There's also...
The Towns of Windham and Greenville are only 15 minutes away, do a search for resorts.
The Glens Falls House is across the street.
I'm not that far and will drive. You can stay right there at Riedlbauer's resort.
You couldn't ask for a better spot to have the event. Catskill mountains. Good food . Huge pavilion. Cold beer. Not sure but should have a band also.
Gets bigger every year. Pre- 1962 vehicles and grass drags.
You may want to run the cable under the wishbone like Glen did. Mine had the cable over the wishbone and it rubbed. It has since been converted....
I was able to bend the tubes down a little. Be careful not to kink them.
Here's a couple of ideas. The previous owner drilled the floor for seat belts, so the damage was done, I just incorporated the holes for the seat...
Separate names with a comma.
The Jalopy Journal
