The Jalopy Journal
Hi I lost 1 trim piece of my 39 ford grill i know its a long shot but maybe someone can help me out with one or maybe have a broken up set...
and air bags installed at the front [MEDIA]
here some more pictures taken outside
when Eric has finished the Plymouth we need to put it on the Coe for a photo shoot.
MAG welding
spotted on the last event of the season in september with a buddy at the wheel and his project on the back (46 chevy) [ATTACH] [ATTACH] here one...
no awards yet over here most events dont give awards
Hi Billy did put a few hundred miles on it without any trouble it cools perfect i even have and pcm controled electric fan as backup, but did...
its 190cm wide and 480cm long 75 x 189 inch and the angle is abouth 8 degrees
Eric is just fine. Had the pleasure to meet him last week on a local meeting in Amsterdam, I am sure He will get back soon with progress :)....
took the Coe to some meetings and shows last weeks and had a foto shoot last thursday evening by a great photographer he took some awsome...
took it to the first show yesterday :) [IMG]
No problem Mike ! :) Posted using the Full Custom H.A.M.B. App!
intalled the engine without heads first and lowered the Coe back on the Ground and then installed heads ,intake and the rest of the stuff, and...
Yes i did . i didnt want to take the risk in not replacing it . And discover it was The or one off the causes And its in a not so easy accesable...
ok some update on the engine rebuild yesterday 99% of the parts arrived from the states. got a remanufactured crankshaft (as it was cheaper...
you need to think creative Mike ;):p <iframe width="1280" height="720" src="//www.youtube.com/embed/GfQlWCufkRo?rel=0" frameborder="0"...
at the first start up i checked and had oil pressure, i am not sure its caused by the fuel, it could also be that the damage started way...
took the engine totaly apart today inspected and cleaned all the parts the cam shaft did not got damaged :) just ordered the needed parts....
here some pics of the damage .... [IMG] [IMG] now looking for a rebuild kit + a new crankshaft. i could go for a re grind, but for...
Yup shi.... happens disassembled the engine halfway down pulled the main bearings and the crank is damaged too Will see if its going to be...
got pretty much done tonight taking stuff apart goes much faster than puting it together :) [IMG] raised it up a bit and half way...
The engine can be dropped from the bottom if i remove the headers. Then lower it on a cart and then raise the truck abouth 2,5 feet on jack...
Yes Leen it did it had a leaking fuel presure regulator causing to soak cillinder 4 tru the vacuum port for a while before i found the...
Ok last saturday we got the seats back from the upholster and made the carpet on the floor to finish the interior [IMG] [IMG] [IMG]...
left of the switch i have a deadpedal to rest your left foot and your telling me to stop showing off ? who itself has made some pretty...
finished the winch cover, a lot of sanding and polishing.... [IMG] [IMG] and my dad my the door panels today up next will be trimming...
i almost thought the same :eek: the engine did not run smooth it ran on 7 cillinders and couldnt get behind the cause :confused: got a...
have No regrets yet Mike :) i just run the stock vacuum wipers Yes ? dont you like it ?? :p:D Hey thats willy's Coe ;) i got...
Got them from epay. But bob drake or similar has them too Posted using the Full Custom H.A.M.B. App!
Separate names with a comma.
The Jalopy Journal
