The Jalopy Journal
Steve, That head sure looks like a 2 pc. billet head. I agree, it should be a Ripper!! John
Dan Eubanks made meehanite iron cranks, steel and aluminum rods and also a couple OHV heads Probably ended about 2010 or 2012 John
Thanks Dannerr! That looks like FUN J
Those Mallory distributors came from forklifts if I recall I have used them also, just pay attention to the advance rate I have found side valve...
Bonneville 2025 [ATTACH]
2 year olds....
Thanks All It has been an Honor to work with these folks Creel, Nelson & Nelson and Kendall John
Bonneville 2025 The week started off with a single run to qualify and a backup run to set the record in V4F/GMR, simple, right? Then we became...
It could have been to adapt a wico mag. J
I have a PoliForm 29 body for sale This is the race version without the rear fender wells and doors solid Included is the solid tonneau cover and...
In my opinion there was not enough knowledge in alum casting Many of the alum Winfield copied heads did not increase the wall thickness to...
ElMirage May 17/18 weekend you tube short Starting line warmup https://www.youtube.com/shorts/1gJc-PdeRMU other vids also, about 3 hour mark on...
Interesting find on the rods They could well be early HAL Couple observations they appear to have shims so likely babbitt, pressure only and the...
Take a look for V8 pumps diagrams J
I was thinking it looked too small also It looks like a Speedway Engineering Mini Stock QC, not sure J
Very nicely built I had thought to maybe cut the crank down for a 2pc chevy seal and thrust off the center. John
That is a nice setup, I wasn't sure how the Burtz crank rear main looked the bearing is shorter. I have had people asking about using with a...
I'd sure like to see the girdle/crank assembly and of course some hp numbers John
Rich’s last build was a DB It currently resides in NZ J
A couple coops from desktop[ATTACH] [ATTACH] [ATTACH]
Typically squish or piston to head clearance is .040 - .060 in. The gasket should provide that amount of clearance if the pistons do not protrude...
Good info, Thanks Warren just as a side note, ARP cannot sell directly other than list price. the good news is Summit, Jegs and others can...
IHMO a proper bearing installation only needs 30 psi at speed and 10-15 at idle There is a rule of thumb 10 psi per 1000 rpm speed I have had GM...
It should be no problem, I have run 100 psi for longer runs at Bonneville with no gasket J
Filling quite nicely Yes a lean to is going on one side next Have you survived the storms so far?
Enough for today Time to enjoy the day J
Thanks for the picture of rotor That will take some work to separate the two circuits and insulate properly As for dual plug heads they are more...
It started shrinking when the roof went on
Didn’t intend to start up a ruckus I guess I will get my hands on one and see Just what I need is another project Hopefully moving machines...
Hmm So I wonder If that could be modified to fire two simultaneous and used on a dual plug head just another project I guess J
Separate names with a comma.
The Jalopy Journal
