The Jalopy Journal
Attached is a pic of the Sag 4 speed case. Took a hellofa lot of pressure washing to clean it up. This comes back as 68 Camero. Probably had...
Checked the Saginaw input shaft groves for the trans that was in the truck. There were no grooves, so that would make the gear ratios as follows:...
Guys Thanks to all of you for your advice and expertise. I'll try to figure out the gear rations for the Saginaw 4 speed. It was most likely...
Guthriesmith Thanks for the advice. I know the TPI setup is not really a Hi Perf install. It is what I have available and it will be an...
Jim The truck is basically bone stock at this point, except for the 1960s drivetrain that was in it when I got it. The bell housing is the OE...
My driving will be mostly local roads but, here in South Jersey, ya kinda gotta use the Parkway (interstate) to get most anywhere up and down the...
Thanks. Deleted th e reference. Was not aware that was off topic.
Need some advice. I'm building a 1956 Chevy 1/2 ton, and I'm trying to decide on a transmission. The motor will be a 350 with 4 bolt mains,...
Jim Thanks for your reply. The truck has a compressor tank mounted under the floor where the OE MC would have been. The previous owner had an...
I have a 1956 Chevy 1/2 ton Apache with a fading power brake situation. The truck is running a 1967 350 SBC from an SS Camero, and a Saginaw 4...
Hello to all H.A.M.B. members. I joined a couple days back but just got around to the introduction. I'm located in South Jersey along the shore. I...
Separate names with a comma.
The Jalopy Journal