The Jalopy Journal
[ATTACH] I already have the glass filter like the one above, didn't think about one for the small blocks, should work, I'll have to check that out.
Anyone make a nice pre bent hard fuel line kit for a pair of Carter AFB carbs with all the fittings for the shorter (close carbs) Edelbrock...
Butch Adams is still around, lives close by.
Thanks guys, and I have one of those crimpers too.
What gauge wire from alternator to battery? It's a long run, from passenger side to drivers side battery
Are you kidding, have always done it all in my 2 car garage and small 14' shop. Current project Rambler, past Ted Brown T rebuild....[ATTACH][ATTACH]
Like to see the Corvair it's in. I'm in love with my[ATTACH] Mr. Gaskets
Turn key 1966 American Motors 6 cylinder, new starter, rebuilt carb, runs good, no smoke, good shifting Flash O Matic automatic transmission, just...
Doing an engine swap on my '66 American Rambler, so not needing this 6 cylinder anymore. It runs real good, no smoke, recent carb rebuild...it's...
Does it really matter.....your spoiled :)
Love this build, read it all this morning.....now finish my coffee and get back to my own garage project.
I have some left over stuff from builds gone buy. All are for small block Chevys. * used Mallory dual point distributor (2748201), comes with an...
Good condition Weiand tunnel ram for small block Chevy, carbs have recent rebuild, there Holley 450's (9776) I have the fuel line, gauge and...
Cool story, and cars....watching this one
My Ted Brown built T bucket pedal
Hauling the mail
Root how did it pan out. Did you get that run in stand done? Like to know the outcome.
So Cool, nice thread....cool '55 ;)
Nice work....
called Pertronix today and talked to the tech. He gave me a run down on what to check, everything checked out but...#4 was bad module, so how much...
I just purchased a used (like new though) in box "stock look" Pertronix cast distributor with Ignitor III installed. Hooked every thing up with a...
Okay here's some more video's, #1 there is some movement in the t/o bearing on the bearing retainer #2 no movement in t/o bearing while...
Yes I have...in the video's the emergency brake is on but it will do this when pulling away from any stop.
No, infact when you let it out past the shaking point it's smooth. I'm going to check flywheel run out here tonight of tomorrow. Clutch is new not...
Until tonight to get that other video I also have this jem [MEDIA]
#1. Yes the very start, now when your letting the clutch out and you can get past gritting your teeth it will even out and be smooth as...
Sounds reasonable, I'll have to check that out
If memory serves me well I believe there was a little movement there. I'm going to make a video from underneath clutch so to look up at t/o...
1. rear ratio is 3.55 2. 2.56 (0 ring) 3. it's an 880 crate (one piece rear main), I would think 2012 that's when the car was finished, looks new...
It was fine, I installed it with an old input shaft
Separate names with a comma.
The Jalopy Journal
