The Jalopy Journal
Squirrels right you gotta remove the fuel pump rod.
I think your perlube idea will work ok, but I would really think about it before I pressurized an old garden sprayer with shop air.Those old hand...
Thanks for all the answers guys. I have purchased and installed a fusebox that was exactly what I had in mind. Car is back on the road and all is...
The car was wired with 8 fuses because of extra accessories, electric fan,fuel pump, a/c etc so the extra circuits are needed but thanks for an...
Thanks for all the input.Found what I needed at Speedway Motors.I think the brand name was Painless also found some good looking ones at Centech.
F&j is right I can't use an original because of the harness swap or I would certainly put an original one in. The car is already modified so...
I am looking for a good quality fuse box for a 56 chev.The car has had a wiring kit installed at sometime(dont know the history) but the fuse box...
The plugs should not normally be wet what is being said is if they are wet its another confirmation of too much fuel or not enough fire to fire...
A few things to check are the carb of course,make sure the plug wires are in the right firing order, check for good strong spark at the plugs,make...
If you still dont find the problem after all the above mentioned checks look at the keyway in the front dampner.I had one break out on a sbc last...
If I remember correctly the left front cylinderis #1 on a sbc not the right as previously posted
btt
Don't beat the hub down with a hammer or you will ruin the seal.If you must move the hub use a press and support the shaft on the other end,also...
Welcome from Cozad Ne.
Does anyone know of a possible source for a fan clutch for a 1962 olds starfire conv.? I have checked all the sources I'm aware of and had no luck...
Just quick thought when you are bending higes you still have to keep the hinge pins in a straight line with each other or the door will bind and...
You might have to change the float levels. Also those carbs are kind of noted for popping the power valves.
I have used this setup on a 32 coupe works pretty well. They are hard to bleed manually because the cross rod keeps articulating until you get...
I guess I would research all 3 vehicles starting at grade 5 and going on up to about grade 3. You can find the grade system in Hemmings and...
It makes a lot of difference which engine your talking about ford made 3 351 in the 60-70s a 351 c denotes a cleveland engine which is probably...
Im with unkl ian how does detonation pull a wrist pin out of a piston? I would bet that the pistons were cast kb hypereutechtics. If so you may...
main caps are numbered 12345 #1is front. arrows should all point to the front. Do you have the rods installed in the right position? If the...
Thanks guys you have answered my question to the t. I need to use oem pump. Thanks again and Merry Christmas to all Hambers out there
bttt
Before I get jumped on I have already went through all the search threads on this question. Can anyone tell me if the p/s pump from a 85 gm car...
Can anyone tell me the color or paint number of the 54 olds concept car that was posted on the hamb awhile back? I think you can find the picture...
It appears that about the only way you can get close to accomplishing what you want to do is to turn one valve cover end for and put the hole...
I know where there is a 41 flathead and trans that run good. If your interested let me know. I sold the engine to another guy but I know he still...
Separate names with a comma.
The Jalopy Journal
