The Jalopy Journal
I put my rear drums on the axles and turn them together.
Can you share how you made your hose clamps?
I left a voice mail at Williamson's 2 weeks ago still no response? Ron please check your messages.
You can TIG weld that broken spacer to the backing plate. I don't use and filler rod just run the puddle all the way around on both sides. Makes...
I'm using the same kit on my project Coupe. Tack everything and make sure your trunk lid fits before you weld it.
DA is short for dual action it's a sander that spins and orbits.
Onekoolkat1950 can you share how you made the knob?
Line up the glass channel. The glass will not bend. You will need long slices to repair the misalignment. I can see a slice 4 inches above and 2...
Thank you Larry for saving this beautiful Hot Rod.
You got, it the picture you drew looks great can't wait to see it in steel.
If you were to use the water pumps that most builders use. The hole in the water pumps for the motor mount biscuit are 20 inches on center. The...
I just measured my 47 flathead with truck water pumps. The motor mount with is 20 inches on center. Your drawling looks great but, your unfinished...
Great job. I make all my threaded adapters from a solid 40 ford driveshaft.
You will be fine wait until you see the runout of those Cokers. I had problems with high speed balancing. It took too much weight. Took half the...
The seller makes very good fakes. For under a hundred dollars it is still cool just not real.
I would turn the motor around and connect the transmission drive shaft to the harmonic balancer. I think you could switch your headers side to...
When I rebuilt my 56 354 hemi I found the rocker shafts and rockers full of oil sludge. It starved the valve train of oil. Lots of wear up top. If...
Good job this car is looking great. I just scored a pair of 37 Chrysler Imperial taillight lenses for my 30 Coupe. Could you post pictures of your...
It is a WIG- WAG taillight you can always find one on the auction sight. Bill
I hope you are saving your paper patterns. I need the lower door post patched on my car also. You are doing a great job. Bill
Flop just sent me the address thought I would share 4078 State Route 66 Apollo, PA 15613
I raced at that track ten years ago. The place was beautiful as a park and the drag strip still went up hill. Thanks for the great memories.
I can save you a quarter. I needed a spring several months ago and called Posies. They will not sell main leaves. Bill
Matt, You are doing a great job. What a shame to cover all that up with a body. I think I would like to buy this one back? Bill
Saxman, Great job on the knobs I attached pics of a couple of my knobs. I like to bend the coins in my press to give the coin some crown. I set...
I found this brake handle in a 60s International dump truck.
I have no pictures of the car. I saw it at a cruise last night and spoke to Bill. He told me the wheels were from a military trailer with large...
Thanks for the positive responses. I was sick when I realized what I may have done. I know the difference in the gears. I just mixed up my parts...
I could not find the engine pics. It is it may have the correct gear in engine. I thought I had one of each gears and the one not in my engine is...
Fronts 6.00-16 rears 750.16 car has not been lowered.
Separate names with a comma.
The Jalopy Journal
