The Jalopy Journal
Right after this t bucket Gary Glenn built the van used in the movie "Rock 'n' Roll High School" I miss that dirty S.O.B.
It's pretty obvious he is the one that made those changes.
Trust me you Really don't want to know this. But it is "their" initials.:eek:
Not here either. But I can click the link and see and see the ad. They are asking $13k
At first I thought the picture was flipped but then I noticed that only the "Powered by 289" was. Wonder why they did that.
A lingering temptation I'm guessing.
No where in the ad does it mention a Hemi. Specifically it says "331 v8 push button automatic…."
Yes and Yes From what I can see that's nowhere near bad enough for there to be any question.
I would like to see some on-topic examples.
Just read the whole thread and think your going to have an awesome ride. My only concern as others is the crossmember mounting. Not because of...
Welcome from another 'gander Looks like your on your way to a killer ride. What part of Mi.? it helps to put your general location in your profile
And repeat until you can sand off the guide coat without breaking thru the primer. Then it's ready to seal and paint.
oh most definitely subscribed.
How 'bout this one @anthony myrick in it's pictured condition of course. [IMG] or the convertible in this article covered in liquid manure but...
FREE Front and rear axles from 40's Ford Front and rear axles from a 1940's Ford. I had them for a project but the project is gone. [ATTACH]...
Just an Awesome thread, Thank you so much. Same goes for @woodiemike PRC thread where I found this just 3 pages in. From post #84 [ATTACH]...
The gilmore is cool but on the opposite side of the state than detroit.
Here's the trailer: https://www.iskythedocumentary.com/
Cool car, Here's a bump for luck.
Please....Please get out of my car. I'll give you whats left of my sandwich.
About ten yrs ago I was asked to design badges for a build. I drew it up in CAD and it was sent to a company that did EDM (Electrical Discharge...
I posted a deuce coupe back in post #786 that is now owned by a HAMBer. unfortunately my pic is gone and I can't find his thread. I don't think he...
Elvis has left the building! or at least one side of the caro_O Good on ya. Hope there will be a build thread.
Save $30+ by buying the included products separately. PC-7 = $13 @ Home depot SEM Plastic Prep = $22 @ local paint supply not really needed...
Lots of mostly good info. When it's broke flush or just a smidge down grab a flat washer and weld it hot to the bolt then weld a nut on top. I...
I've used Dynomat, Killmat, Noico and Siless. They are all 80 mil. butyl and neither I nor my customers can tell the difference between them. I...
I'll see your Continental and raise it a Zephyr with a 331 Cad.:D Rare 1941 Lincoln Zephyr Club Coupe - $2,800 (Austin)...
You do realize that #4 cable is NOT the same thing as 4/0 cable, which is a much larger diameter. #4 cable is what the factory likely used for...
@Pist-n-Broke That would only apply if there was a fulcrum involved @Ebbsspeed is correct. As mentioned the traction bar should make contact at...
Yep, It now says $37,500
Separate names with a comma.