The Jalopy Journal
I have been trying to contact Dashman for about a month by phone and email. I ordered 2 sets of flat caps from him last year and still have not...
Von Dutch's motorcycle is now at Antique Archeology's (American Pickers) Nashville store. I saw it there last week. The MC was the best thing...
Shocks are sold.
BTT
Bump
8" rear out of a Mustang II. 3.00 gears non posi. Approx. 57" outside of drums. Brakes were working good last year when I was driving the car....
Viking Mustang II coil overs. These shocks are adjustable for rebound and compression. They use the tapered springs that fit the MII upper...
T5 trans out of 80's Camaro/Trans Am - not world class Hurst Billet Plus shifter Bellhousing for small block 153 tooth flywheel for 2 piece rear...
How about covering the wheels with some screw on Moon discs?
Here's the engine in my T. [IMG] Mike
Can't argue with that!:D
I ran 3x2's on my 46 for about 12 years and currently have a set on my T. If you set them up with the correct end carbs and run progressive...
Here are some pics of the one I built for mine. [IMG] [IMG]
Here's the one I made for my T. [IMG] [IMG] Alternator is a small Denso unit off of a Geo Metro converted to V-belt.
I don't know what solution Hotroddon has in mind, but I have been looking at doing a 4 +1 OD with a Saginaw 4 speed. I have an HEI, so I would be...
I'm in Louisiana. Been a while since I did an antique, but I will try to help. Keep in mind I did this about 15 years ago, but I have done a...
Sorry, that wasn't me. I live in Louisiana. Yea, pretty much everyone that came over helped me wear the dirt a little deeper.
I had a Simplex with the same frame and a single Briggs engine when I was about 9. Didn't race it, but put untold miles on it in the yard. Wound...
Motor can should be pointing toward the ground. Electric terminals on the bottom. The motor can is intended to fill with fuel while the pump is...
Did you have it mounted with the motor down? Carter's mount that way and are cooled and lubricated by the fuel.
Glad you're OK. On my T bucket, I put a Ford impact cutoff switch in the ignition circuit to the MSD box. It may not have prevented this...
Be sure to check the laws in your state BEFORE you start on any project that involves combining serial numbered parts. The damn chop shops have...
Here's my nerf bar setup. I originally was just going to mount the taillights in the bed, but thought it just didn't look right (to my eye...
I pulled one similar to that out of a 90's Trans AM. It was an Auburn cone style posi. It's in my T now.
Actually it's not that bad. I've driven my bucket in rain so hard you could barely see. The one time it did get wild, I was deliberately trying...
I put an Auburn limited slip unit out of a Trans Am in the S10 rear under my T. I've never had a problem with control on hard launches EXCEPT the...
Separate names with a comma.
The Jalopy Journal
