The Jalopy Journal
I went in your place mate, was a good day with some cool cars.
Gotta be a hell of a squint though, jeez they put me off a car,
Without being an arse , why are those terrible looking bolt on 10 spoke wheels allowed ?
Ok, probably solved it. There is a clip that is missing the 12213 retainer clip. Will try my old Ford parts guy over here to see if he can supply...
Yes, that is what I have, the old one and the one I just bought are identical, and loose ?
Mine is U.S built, has the 12200 style rotor. have just had a look in my Dennis carpenter catalog and it shows a piece between the rotor and...
Just the rotor, shaft seems tight enough but has a step at the top. It's almost like there should be a spring type clip to keep it tight ?
Mine is 58695.
Snap ! just bought one too, but mine doesn't have the auto feed drive. Also need the flat belt, a "helpful" person cut it off before I went to...
Mine, imported it from Rancho Palo Verdes in 2004, been a long time full strip down body off build.[ATTACH]
Are you doing it yourself ? It will come up alright but there will be a lot of pits that will not come out. I have done a few manifolds by hand, a...
Hi guys, the rotor in my y block is a loose fit, moves backwards and forwards roughly 3/8 ". I bought a new one today hoping for a snug fit but it...
Well, for the nay sayers I finally got my #84 in the mail box today in New Zealand, bought it 11/11/2020 at a cost in NZ dollars of $39.80. To be...
I am in New Zealand. I ordered #84 back in November 2020, never got it. When the new round of emails came out I emailed TRJ in August 2022 to see...
Got this cool old lamp at a vintage car club swapmeet on the weekend.[ATTACH]
I would put money on it being the same tool. The guy I gave it to has never come back to the shop to know if he used it or not.
yep, done the same and bought one like #39 too and have found it really good but the bend radius isn't as tight as it could be. Works for me though.
They are possibly the worst tube bender made. I bought one to do the brake and fuel lines on a 57 Fairlane, the bends are nasty and you need hands...
It's a Hemi, of course it's photo worthy. For instance. 1955 331 with the triple nickel heads.
Thanks for the replies. I will put the hole to the bottom just in case.
It is the Fordomatic transmission. There are two holes horizontally top and bottom to the seal area at the rear so I guess the hole in the bush...
The tail housing bush on my 1956 F100 has the lube hole at the top. I have just pressed it out to put it in the right way but there is no hole to...
I think you are on the money here, I had a 1959 300E Thames panel van years ago. The grille matched the orange one above.
Thanks for the replies, a bit more reassuring I haven't got the switch adjusted wrong.
Gidday Lee, had problems with the brake master cylinder, got it sleeved and ran out of holiday time. I think this switch is all I have left to do...
I have it set to only start in neutral, will have a bit more of a fiddle with it tomorrow and see if I can fine tune it more. Thanks for the reply...
Will the factory auto behind Y block start in park ? My book doesn't state clearly if it should, only adjusting the switch to neutral ? More...
My Ludwig Speedking pedal in my F100
How are you getting 55 lbs for a set of wishbones ?
Separate names with a comma.
The Jalopy Journal
