The Jalopy Journal
^^^^ my thoughts also
good luck in your quest (note the date of post)
:D:D:D^^^^
I think you have to PM the seller.
the shot of the camper from your ride is too dam cool
the v8 emblem is pre 54 wonder if they used 52 53 fenders?also missing the trim below grille.clean looking non the less
he is right ^^^ it is messy to clean off
now annete is a different story:)
that is just not right ^^^ grotesque comes to mind
the problem with them would be them not being correct as pretty much all brake shoes look similar.those could be something put in that box.just...
I am certain that blade is not off the 54
I am with Rich the only thing I see is a drain on your wallet.good luck
you state the rear cylinders are you think 3/4.I would confirm that and look at a 13/16 or 7/8
if you remove the kick panel you can access the one mid way up fender
the aaca has a section titled what is it?you may want to try there a lot of knowledge.good luck be a shame to butcher it without knowing.it may...
with 10+ years having past I think he solved problem or is living with it
so what did they do with the ute?
one thing it would be a good idea to fit a big flat blade (wide and thick) to do the nut up.they sell a tool but it is almost useless as it has...
I think welding and then the effort of finishing them too would be a huge effort.easier and more practical to seam seal.no worries about burn...
you will be good as the 6 volt drew (draw) a higher amp load on switch
good luck as finding them will be akin to finding good used hood hinges
looks like a bubble skirt convention :):)
they were factory spot welded to floor and inner rocker panel
Methuselah just stirred
is that not the standard answer:D:D:D^^^^^
could not have put it better some just can not make that leap^^^^^
with -19 they are waiting on their suppliers also ^^^^
one more off the to do list:D
me thinks he did not remove axles;)
just make sure if and when that it is a 54 a lot do not realize they are unique good luck.
Separate names with a comma.