The Jalopy Journal
I had this tag reproduced by the local trophy shop for a friend's 32 3W. Not exact but good enough for him [ATTACH] [ATTACH]
[ATTACH] Convertible body with that model
[ATTACH] I had a copy of wheel rate calculation chart (?) and other suspension data however I'm unable to locate. Kerrynzl would know a lot more...
[ATTACH] [ATTACH]
This one has been languishing now for years! Lack of motivation, other distractions, everything else seems to take precedence. It's now a roller...
[ATTACH] https://www.bopparts.com/pontiac-see-details-front-suspension-bumper-2-pieces.html
I added a delron bushing with inner bearing, there's circlip groove on engine side of inner shaft and a collar on inner shaft (Inside tube) to...
Heat with torch and push crayon onto thread where it screws into flange
Limeworks instructions may assist and detent gate. [ATTACH] [ATTACH] The following is from X38 and how he modified his column for auto trans....
An old thread by Marty Strode, flatten it.
[ATTACH] [ATTACH] Down here similar style flat bar or flat plate brackets are inserted into upper and lower boxed sections, they're drilled/tapped...
Mandatory down here for all modified cars. Closed cars require 3pt restraint (Preferably retractable on outboard seats), 2pt restraints on inboard...
A long hiatus with not a lot of work to show due to retirement, family, travel and waiting for others to finish various odd jobs that will allow...
9"-v-8". 8" is flat on top and bottom by comparison. Check the axle flanges to determine bearing size. All retaining nuts are easily accessible on...
Model A firewall (Body) modified to fit an OEM 32 frame by HAMBer (Flop) [ATTACH]
Exact reproduction at Gilmore Museum using a copy of original blueprints [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [IMG]
[ATTACH] All I have
I finally located the roll of bitumen board, made some templates and cut the required patterns after I masked the areas up for some spray glue. A...
I recently had my NOS OEM 46 Olds caps modified by The Wheelsmith to suit my new steel rims that use nibs to secure cap and not springs. My OEM...
[ATTACH] [ATTACH] [ATTACH]
Don Garlit's[ATTACH] [ATTACH] [ATTACH] [ATTACH]
Speedy Bill's [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Flathead superchargers [ATTACH] Frenzel supercharger in a sea of Arduns [ATTACH] Dixon [ATTACH] Tornado [ATTACH]
Maxi-F head on Isky stand at Speedy Bill's Museum of Speed [ATTACH] Tri-power Ardun with U-fab intake, again at Musum of Speed [ATTACH] Reverse...
I finally put all the new window run channels in the doors and rears 1/4s, installed the new glass and my NOS vent shades. I had to install the...
I borrowed a friend's MECO double flaring tool, it was old and abused so it broke on me. Most likely it was only a matter of time. I didn't...
I just received my wheels from thewheelsmith for my 46 Olds sedanette. I'm very happy, all I need to do now is add the rubber and it's another...
Hot Hemi Heads
[ATTACH]
In a heart beat however that's not for me. No mod cons, electric fans, hair dryers etc;)
Separate names with a comma.
The Jalopy Journal
