The Jalopy Journal
Had a 68 Camaro painted with 1977 Lincoln Dark Jade Green. Almost black.
Are they of any value for light engine machining jobs? i.e. broken studs, valve seats, etc.
The Cragar catalog in 1963 shows that set-up.
Chirp, chirp, chirp....
I would add an intake and check carb flange with a level. Tilt can effect clearances.
Small hole made by a rodent sounds feasible...has suction but not enough under load.
Don't laugh. I had a 305 performing similar stunts. Timing changes tried forward and backward. Got a tank of non-ethanol fuel...you would have...
If you are in need of garage space after your run at MIR on Thursday, have A.C. and a concrete floor. Only two miles off 301. About thirty miles...
Curious. Do the rear seats from Jeep CJ/Wrangler work in A's or T's? Never noticed them used, but they appear to be close in width.
Mine wait til I've pulled my pants back up.
Duct tape, electrical tape and baling wire.
Popping noise sporadic upon acceleration or steady? Does popping occur in neutral, revving engine as well as while accelerating under load?
Coolant=white smoke. Oil=blueish smoke. You're on the hunt now! Check for bubbles in cooling system while engine is running. If present, re-torque...
Could it be that the oil additive he poured in the crankcase first, still be siphoning in from the same spot as the coolant He still has not...
He could loosen the oil drain plug and see how much coolant, if any, has entered the crankcase. If none or a small amount... no harm -no foul. SBC...
Start with intake manifold bolt torque check. Next pull intake manifold. Check gasket interface with manifold face and cylinder head face. Cracks...
In your first post you said engine smoked; blue or white? Sure looks like moisture on piston top. When did you add this Lucas additive? Before you...
How did the antifreeze get in the valve/runner area?
Looks like antifreeze. He needs to pull that intake and check that gasket. Looks like water in oil also.
My 35 Plymouth uses an early 60's Chevy van axle. Has about a 4" drop, but was narrowed.
John Deere yellow equipment enamel...
If dogwood is dry and stable, you can turn it to make small knobs. Used as wear blocks and idlers for chains. Hard stuff. Boxwood is another good one.
"Better to have loved and lost, than never to have loved at all."
Shuda'-Cuda'-Wuda'
Mmmmmm! I will say that anyone who would try using one of these hoops; they tip easily when you lift them from the on-edge position, so with the...
The bale rings last a couple years...cow's mileage considerably more. Steers and heifers for slaughter...about two years.
I have 10-12 cows weighing 1200-1600lbs, pushing on them all day...they last about two feeding seasons.
Minter's Auto Body across the bridge in King George(205&301). He does projects other than insurance jobs. Have no idea what he charges, but his...
Comes in blue, also very close to color of D-Russ's vicky. Years ago kids' Tae Kwon Do instructor used it for tips on belts.
"1/4 inch nut in a small soup can"... Something rattling under the timing chain cover? If rockers are intact and not making contact with the...
Separate names with a comma.
The Jalopy Journal
