The Jalopy Journal
711HP, 634 TQ Best of Luck to you!!!!
Maybe check Steele Rubber Products?!?! I think they're online...
I used a Ford Fairmont Master Cylinder in my 62 Olds, a slightly different bolt spread, but worked after about 2 minutes with a file. This put...
Are you refering to the G Body, A Body or the original poster's Y Body? Just looking for some clarification...
Here's mine from about a year ago... I have since done some bodywork and drive the hell out of it! Andy
my 1928....
I have a WEG VFD I have used for several years... Much easier than anything else. I think I bought it at M & R Electric in Dayton for $150. For...
I've seen your car out and about, though I don't personally know you... As seen above, I did get pulled over by OSP on Sunday for that one...
I passed a state trooper on Sunday afternoon in my slightly OT 66 Buick convertible in Beavercreek, just outside of Dayton. I was doing nothing...
I'll play... 1928 Pontiac 6-28
I'll be in Vernon Hills...
I have to go to Chicago (NW side) for work the week of July 18-21. Are there any good Hot Rod type stops / events in the evenings during this...
Where in Ohio are you?
There was a guy that had a complete turbo set-up on evil-bay, but he wanted more for the top end than I have in my entire car...
I wish mine was a Jetfire!!!
If you can't weld good, weld allot!?!?!
Perhaps... It is difficult to document your mechanical skills with industrial equipment. It is frowned upon to take pictures of machines that...
Good looking car. I would've loved to have found an OHC 6 for mine.... Still looking though. FWIW, I like the fenders on it. I ran mine (28...
I used to use the Mityvac... Now I have a vacuum generator I scrounged that I hook up to the air compressor. It uses the Bournouli (SP?) effect...
I have a 66 Buick Skylark convertible. Though I like the sbc, I would vote to keep it all Buick. I bought a core Buick 300 several years ago,...
THANK YOU THANK YOU THANK YOU!!!! PM Sent... My Mom was right, I'm not always going to be a loser... These will find a way under my car...
#28
Sorry to have just found this, but an early 80's Ford Fairmont M/C works well in my 62 Cutlass. As for aftermarket wheels, good luck, 4 x 4 1/2...
2 votes for Vintage Air.... Any opinions on the other manufacturers? Thanks! Andy
This may be slightly O/T, if so please forgive me... I am looking at adding AC / Heat / Defrost to my 1962 Olds F85 2 door hardtop. Currently, I...
Not to Hijack, but I guess I am... I have a lot of Olds 215 parts I need to sell, almost a complete engine minus block, pistons and rods, but...
I gave $600 for a two door that was wrecked (New dog house) and was missing the 215 block about 3 years ago. I have about $1500 in it now and it...
I was there... Walking around it seemed like there was about 1 in 5 "late models" (post 1948)... That being said, if there were 10,100 cars...
Damn, calm down... It's not as if he published an address of where to find the cars or where the owners can be found so they can be punished for...
C-V: Looking and talking, not from HB Classics, but I am sure a guy could find a set of fenders and make them work... I am not sure about motor...
Separate names with a comma.
The Jalopy Journal
