The Jalopy Journal
bump
I'm trying to put a Tach on my 51' Hudson, but I can't figure out what I need. The car is still running its original 6 volt positive ground...
I posted about clearing it the other day, and some people wanted some pictures so here you go...
I have a 1951 Hudson positive ground 6 volt. What I did to eliminate this problem was to run my own wiring harness. I ran a a wire off of my...
^ No I'll probably keep it to the day I die then leave it to be my kids problem
Thanks for the Help. But yeah I guess you could call me lazy for not wanting to fix rust, but it also doesn't matter when you have replacement...
I personally like the look of cleared patina, but I don't think that when you clear it you make it fake. I just want to clear it so it still looks...
Hi All, I'm going to start clear coating my 51 Hudson, but I have a few questions. How would I clear the paint trying to save all of its...
Extra re-enforcing rib where is it located? I'm just asking because I have a 262 that has an issue fitting a normal 262 head gasket.
yes that is correct the postive terminal has a strap to the frame, and also the same for the starter
I have to coil installed correctly, with the correct wiring. I gaped the point at its correct .020", and it does have the rotor on I actually...
on the coil side. How would I run the wires on the coil. I have a positive side and one side that says distributor. Would I hook this up opposite...
I will check this tomorrow. On the coil, how would I run the wires? because it is a positive ground car
Okay thanks I will check tomorrow
Hi All, After cleaning, gaping, and replacing the condenser on the distributor. I was ready to crank her over to she if she had spark, but when...
I hot wired my car today. Starter works, and I'm getting power to the coil. Now the distributor decides not to make spark. So tomorrow I'm going...
Thank you for the information, and help its greatly appreciated
Hello All, I have a few questions about hot wiring my car. I have a 51' Hudson Commodore 4 door which weights 5,000 pounds so its not easy...
Parts are hard to come by. But Kanter, Napa, Rock Auto, Ebay, and a few others carry a parts.
Hi All, I am new to the H.A.M.B, but have a few questions about running a compression test. I have a 1951 Hudson Commodore 6 with a straight...
Hi everyone, I just recently found this site, and its probably one of the best out there. I have two classics one a 1951 Hudson Super 6, and a...
Separate names with a comma.
The Jalopy Journal