The Jalopy Journal
Back in the 60's we carried a big bat if they didn't dim there lights.
Hi I have a 454 chev with a 6-71 blower with 2 Holleys that I referenced my self. I plugged the vacumn port under the carb base and then drilled...
Hi Just take the solenoid apart and add the pin or install a new sol. with the bypass.
Hi Take a venier and measure the top and the bottom of the shaft and the wheel and you will know how far the wheel will go on the shaft. Regards Dave
Hi Check your power valves unless you have back fire checks in the carb. You say you think it is loading up.
Hi The spacer was not to raise the car when not moving. There were for when you left the line and hammered the throttle the front end would raise...
Hi I have been down this road also with the chrome pan. Changed the gasket a few times and finally threw the pan out and put a normal pan on . no...
Hi It sounds like the timing is to far retarded ( adjustment or dist. weights sticky or seized or in wrong) as it is back firing out the exhaust....
Hi What keeps the slider from jumping out of mesh is the three dogs and spring on the slider and there mating gears if the gears,shafts and sycro...
Hi What about engine and motor. Or jugs on a crankcase.
Hi If the belt is on. On second thought even if there is no belt and the engine is running
Hi Just make sure it does not have plastic pulleys. also has good cables and lock system. I have the Atlas 8000 and has been good. The only thing...
Hi If you use any carb's that have a vacume power valve set up, make sure that you reference all of them to, under the blower and NOT under the...
Hi I have a small bearing 327 that was built in the early 60's with a 471 BDS blower, flat top forged pistons. It has small rods, steel crank,...
Hi just spent time reading all the posts with interest. I to built a blown 454 chev and ran it in a RED. The heads had Manley valves. What happen...
I have a princess auto blaster cabinet with legs. The problem I have is the reflection on the glass and can not see in the cabinet. I have...
Just read all the posts and hope the problem is fixed. I agree with some posts as well disagree with others. I have all my life had sbc and bbc...
I agree what Baumi has said. Also in the second pic. When you finish cleaning the block,Don't forget that top plug. you can not put it in after...
Cooler line pressure is convertor out pressure. when it returns from the cooler and enters the transmission it becomes lube pressure. Condition...
Separate names with a comma.
The Jalopy Journal