The Jalopy Journal
When all the dust has settled.I think you will spend more on a system not made for your car along with the expense of Tylenol.
Iam thinking the reason bulb bases break off in the sockets. They used to be made of brass and never seized in the sockets.They are now made of...
Thats thinking outside the box,nice work.
In most cases the only way to get it running when the spark plugs are gas soaked is to replace them.
Looks fantastic with an unmolested body and standing with an attitude
In the early 60s working in a gas station,I had a job of flushing the cooling system on a Rambler. Rambler was like a mutt, it used parts from...
all the valves moving as should, poor gas
I have 1 with glass lense and non pitted chrome bezel for sale. It does have mounting screw holes top and bottom. It measures 3 5/16 od and 2 1/4...
It seems like wiring in a ford starter relay would cover all your bases for both starter and ignition. Are you now using a ballast resistor ?
Air chisel to remove them, proper size socket to drive new bushing in with hammer. Tighten bushings to control arm crossbar with car full weight,...
Have you considered animals or rats & rat nests burning in the exhaust system.If you are not loosing any fluids it is either rats or your trip...
I would look at other things. Head gasket, if power brakes is brake fluid leaking out rear of master and vacuum sucking it into intake. I have...
I have made a spring compressor for the clutch drum spring with threaded rod, scrap steel and mig welder. A 25 gallon metal barrel with the round...
I have ended lockup shudder many times when nothing else worked with a product called lubeguard .Its a friction modifier ,not snake oil
To prevent ever to replace again .I have always used disk brake wheel bearing grease on the gear,track and rollers and any moving parts. It...
All Chinese parts ?
The plastic "doohickey" would be for all types of valve seals for all makes of cars. To prevent the seal being destroyed being pushed over the...
It could be me but I find it hard to understand how you wrote you did this repair. Did you use the plastic sleeve thats sometimes supplied...
Dont go down the rabbit hole that braking that creates a left or right pull is only from the front wheels and not caused by a bad rear wheel...
As said before a shop manual would be your best investment. The bottom return spring you have, I have seen used on the self adjuster lever on 3/4...
The thumb on the flat spring that fits on the parking brake strut or bridge bar goes behind the brake shoe not in front. This holds the park strut...
The safest you could do is order the shop manual for this car and then do the work. Sorry,You will probably have to bleed these brakes the hard...
Also agree with this,(was ase auto tech and shop owner 40+ yrs)
There is another procedure to get the air out of the system on a angle mounted master cyl system when raising the car to level the master cly....
Have you tried jacking the car up so the master is sitting level and then bleeding
318 had smaller ports than 360-340,the reason for Chrysler smallblock gasket difference
318s always used steel. 360s used the paper. 3m yellow on the cork end rails on block side only,allow to dry completely so they wont push out.Bead...
Is this still available ? It's already priced at scrap prices but Will you take less? Will you deliver or meet me half way ? Ill be there in...
They fall down the cowl vent. I would use a cut to fit black window screen under the factory (usually plastic grill) on my cars to prevent this.I...
Try raise all 4 wheels off the ground and have someone apply the brake. Then try to spin each wheel,will let you know what's working or what...
Separate names with a comma.
The Jalopy Journal
