The Jalopy Journal
PM sent
Brian Only changed the hat and idle nozzles? Jeff
Those that are running an aftermarket aluminum head, are you plugging the stock oil drain back holes ? Or does a stock Mercruiser head gasket...
arse I would call Harland Sharp. They will sell you a half set of each.
arse I have been in the auto parts business since the 70's and the performance parts business since the 90's. The last 2 years have been brutal to...
I fully intend to order made-to-order pushrods from Manton. I just wanted to know the OEM length so I could order a pair of pushrod length...
Never mind, I just found some pushrods in another box of parts. Appears to be 8.615" to 8.620"
I want to order pushrod length checkers.....
I have an Edelbrock head, so I would assume close to stock length.
How long are the pushrods? Need to order pushrod length checkers. My build is a Johnny Cash Cadillac, one piece at a time, did not start with a...
Thanks for the input. I always liked black stuff, rattle can freindly.........
Has anyone tried to strip the black paint off the block ? If so, how did you do it ?
So, why LH thread ? So it will unscrew itself ?
Only if you tell us what you're using it in:D To drive either a fuel pump or magneto (or both)
Thank you very much Gentleman !
Can anyone tell me what the thread is in the end of the cam snout ? 1/2"-13 LH ?
Greg I believe these are the replacement bushings only............
I ordered in a 500 ohm 10-turn pot for just that reason. Thanks for the input. Jeff
Brading Thanks for the link!! I will have to build one of those. It will probably go in the drawer with the other one-time-use tools I already...
Guys Need to figure out the ohm rating of a 1949 I.H. KB-2 fuel level sending unit. 1950 & up is the common Ford/Mopar 73-10 ohm, but I cannot...
Thanks Tim!
Anybody have an original Chassis Research TE-440 pitman arm? I need the center-to-center length. Thanks in advance. Jeff
Thanks Bruce I will give that a try. Jeff
Guys I am looking for an original drawing or blueprint of the V-8 Ford Banjo or Halibrand ring gear. I seem to remember one listed...
Guys Back in the days when they still used the Banjo Ford rearend in front engine dragsters, how did they shorten the axles up? Not wanting to...
Let's keep the ball rolling here guys. I'm sure Mike will accept donations if you can't donate till pay day. Jeff
Don't know if any of you had seen this link, but it's worth looking at. www.museumofamericanspeed.com
Hi guys, I keep an eye on the HAMB almost everyday. Been making a living in the HotRod Industry since 1972. Have build several cars over the...
Anybody out there know of a company that was called Repka Engineering that made a set of DOHC heads for a Nailhead Buick. The heads are steel and...
Separate names with a comma.
The Jalopy Journal