The Jalopy Journal
Cosmic. You got the stock floor pan? If yes, are you bottoming out?
It's a 52 btw. It rides great actually. The worst thing you can say is if you get a couple.people in the back it bottoms out on the drive shaft...
I stepped mine and cut 1/2 a coil. 3 inch blocks in the rear. It sits level. Maybe using your original coil springs and cutting a coil will get...
Bump
Anyone? This is a pretty bad ass set to add to your collection.
Thank you
rear wheel houses are always rusted out. Always!
Bump Posted using the Full Custom H.A.M.B. App!
Make reasonable offer please Posted using the Full Custom H.A.M.B. App!
This a near mint set of Service instruction manuals and Service Requirements manual that accompanies a set of films (now on YouTube) Rare. Not...
This is a cool old drivers school bus seat from the 60s. Nice and solid. Easy to copy the design to make another for a matching pair. Or would...
I have 7, 16 inch Ford steel wheels for sale. All have tires, most hold air. Please private message, email call or text. 5074294973. Parts located...
I Posted using the Full Custom H.A.M.B. App!
Bttt Sent from my DROID device using the TJJ mobile app
Anyone?
You lost me sunbeam
Are you talking about the oil distributor plate on the drivers side of the block? The one with the 3 screws holding it down.
Anyone try this on a 49-52?
So now I'm concerned that some of the internal oil lines might be plugged up with sludge. I want to pull the oil pan and check that the oil...
<iframe src="http://www.youtube.com/embed/FmjfTDH2irM" allowfullscreen="" frameborder="0" height="315" width="420"></iframe> short video
I got it running this weekend and oil coming out the rocker weep holes! I removes the filter and capped the lines, then I unscrewed the fitting...
Is there a trick to getting the third flat blade screw out of the oil distributor cover?
More good advice waldo! Thank you, as soon as it gets above 30 and stops blowing snow ill work on it some more.
"OF plumbing" ? Oil flows through the top hose, unless I plug that line with my finger, then it comes up from the bottom hose.. I'm still unsure...
As soon as I get my compressor hooked up ill try some air through the lines. Where is the other end of the line that feeds the rockers? It goes...
On the drivers side of the motor: one line appears to go straight through the block to the other side. The other enters the block about half way...
I pulled the filter off and cleaned it out, no sludge at all, small hole in center tube wasn't clogged. [ATTACH] Spinning the oil pump with a...
I used a power drill, and it pumped plenty of oil into the bypass filter, I was drilling in the clockwise direction, which I'm damn sure is the...
Separate names with a comma.
The Jalopy Journal
