The Jalopy Journal
Sold and shipped!
SOLD------This is a rebuilt GM 6-71 blower with that old school look. It is ready to bolt on and run. All the machine work has been done, and the...
GM-6-71 blower ready to bolt-on and run. This is a rebuilt, machined and set-up blower with all the tricks already done. Case has been trimmed and...
This is a fresh conversion of a hard to find blower. It's been totally gone through and machined for hot rod use. Rotors are triple-pinned, front...
repost
I have 2 pair of door sill scuff plates that are new still in plastic wrap. These fit 1937 Ford 4-door front, 5 window coupe, and sedan delivery....
Hilborn 4-port "G" model injector that has "history". Hilborn thinks it was on Don Moody's fueler back in the day. It has barrel valve and a nice...
This is a really nice Hilborn G-model with history. Hilborn thought it was off of Don Moody's fueler. I have the original purchase/build order....
These are old school magnesium blower drive pulleys and idler for 2" belts. They are used and had some mods but very usable. the drive ratio will...
If it's good it's not cheap-if it's cheap it's not good!
This is injector number 144 that was off Don Moody's fueler in 1963. I have the build sheet from Hilborn and it's the correct one. No cracks or...
bump to top
[ATTACH] Crietz automotive dual 4 manifold that has been converted to a 4-71 blower manifold with a machined aluminum plate. This has a pop-off...
What I use between the rotors is 0.011 for timing, this is the most important clearance. The rear plate clearance to rotor seems a little tight, I...
I built a blower manifold for a flat motor from a 4bbl and added a billet plate to the top for a 4-71. It worked great and I could do another one...
How much power gain do you expect to gain? I think your talking ounces of boost rather than pounds of boost and that's at WOT. I'm intreaged at...
Thanks for the hard work on the picts.
20" wheels-now that's traditional. kinda like turbos on rusty cars.
If the bolts broken off flush with the surface, center punch and drill a smallish hole through the bolt. I usually put some kind of penetrant in...
I kinda hope this catches on. I've gotcha covered in the blower parts. I have a few 4-71s on the shelf.
What did you have in mind for rules?
So did I. Ryan is correct. My cars got a round tube chassis and narrowed rear end. The HAMB is for traditional cars. I'll put something together...
I have a couple of Sun dist machines and the strobe works on neither one. I want to build a Pulse Amp but have to fix the strobes first. Any...
Flux welder welds look like pigion poop at best. save your money and buy a gas shielded welder, even a HF you'll be happier in the long run. If...
I'd borrow a pressure checker form autozone or some one and cap off the water pump outlet and pressure up the thermostat housing, that'll tell you...
Can you still buy them? Brings back real old memories and good times.
When your building those headers from pre-owned units they weld a lot better if you blast off the old paint first. They are easier to paint or...
Nice clean oil under your buddies car at a carshow. Water if you want to be "green"!
I've done a good number of strange combinations for blowers and would recommend that you start with something more common due to cost. Also beware...
Been doin' it for a long time. ask Kerry! gary_r@cox.net or call 316 393 1105
Separate names with a comma.
The Jalopy Journal
