The Jalopy Journal
Picked up a trip power manifold with three carbs A few years ago. Has 3 different Ford carbs… 59, an EAB,& EC. Do I need to find better and...
You could make the center bar from a 55 f100 grille, take a little work but doable
They only go on and work one way
Seen the kits, don’t trust the bolts Installed Aerostar springs, looks good might go a little lower but undecided . Have not seen any comments...
Had mine done at a trans shop in town Pressed in the new bushings Replaced worm gear I disassembled/re-assembled
Mineral spirits
Dealt with Owens myself - got a great rt fender for my merc
Ford=Too expensive
3m self leveling seam sealer would be best #08307
Always, always always hang doors first , line up fenders on any car, truck
Dorman has them, just make sure of thickness of it Otherwise not enough room for spring hooks to go on. I probably have some in a box with dorman...
Braces need to be “flexible “ for vibration Using a stiff adhesive will eventually break free There is a flexible adhesive used on modern door...
Yep
Awesome!!!
truckrod55@hotmail.com if you want to contact me there
Yes- I'm looking from the lower hinge opening down to bottom of rocker thru to the inner down & back on the rocker to the 1st "oval hole - rt & lt...
Yes, -pics Please
what kind of shape are the lower "a" pillars (bottom of front hinge post) ?
I don’t trust “resealed “ tanks Coating let go and I had the same mess Go with a new tank, my 2 cents
Something like this...keeps bolts from backing out
great job, just one thing...where's the spare?
where are you guys putting your electric fan switch(controller)? 54 mercury y block
Current2classic has floor pans , rockers and quarter sections C&G Ford has sheet metal also Along with mills supply,inc.
I used Mills sheet metal for my rockers I believe they have inners also Can’t remember where I got the rear quarter sections And drop downs I...
Committed to buy They asked for my zip for ride cost 10/26 Replied back 10/26- no response Texted 2 days later again no response Texted today......
I always pretty much trusted the guys On this site very pretty straight up guys , Most the guys have dealt with are. I contacted one about a...
I got a kit from Mac's - kit is end pieces only(floor to inner rocker) go about 3" in on the floor crossmembers. I only used a couple 2-4, don't...
looking for a door- hinge pocket on door crushed-repairable but a lot of work- However I could use the Rt & Lt post from the bottom of rocker up...
just putting the feelers out there- my left door lower hinge pocket crunched up and termite holes on the bottom...contemplating replacement....
Separate names with a comma.
The Jalopy Journal
