The Jalopy Journal
Looks like the answer to my own question is no. After speaking with a few film mfg the common response was that they have attempted to create a...
You're spot on. Although the cam was specifically ground for this motor, and the cam card with all the specs identified it as a 325 cam, in fact...
So it may be obvious that the proceeding post are ancient history, and they are. Its a real shame that this motor sat in the corner of the garage...
Yep been checking on the prices of replating the plastic parts, best quote is 600$. Ah no. Ok so some of the hydro-kits run 80 bucks which is...
So the fake "chrome" plastic dash in my Ford looks horrible and replacements, if they can be found, cost about the same as a motor rebuild. So...
accurate screw is a good source for shoulder bolts. If your worried about head height can you use a csk head?
so I pull the rocker covers off my bought-at-auction hot rod and find I have 15 roller rockers. And one stock cheby part. So the rockers are...
drove the 29 for the first time yesterday and ruined a front tire. Dosen't take much of a bump in a turn and the tire hits the fender...
so I have this 29 AA stakebed, and I want to hang artwork on each side of the bed. Not just a sign but something with some class. Perhaps even...
got em, is the the Hamb great or what. Colker tire distributor in Long Beach had them in stock thanks for the help! yes an intertube is...
who knew it would be this hard to find tubes for a 17" (1933-1934) wheel. any suggestions as to a source?
same question and the same desire 'cept the coupe has a muncie. Has anyone gotten that combination to work?
I know all this was on the how-too section of this site but for the life of me I could not find a suggestion as to removing the mo/yr tags. Yes I...
I think this came up in the BJ auction telecast Sat. But what happened to the car(s) that were used in the film?
How would be the best way for someone to contact your about submitting a car for the event?
she's a full fendered enclosed cab with a 260 ford and genuine ford-o-matic. Old style round t fuel tank in the bed. From the top of the tires to...
MY BAD the truck is a '29 (gotta learn how to type) Ok with that correction are the first two options still applicable? A t spring is a lower...
Ok so I like the look of a model A spring. But the rear of my 19 sits about 5 or 6 inches too high can I purchase a new reverse leaf, have it...
Ok so this should be simple, but so far no luck. my so-close-to-finished-it-hurts 29 truck has a late model rear with a spring mounted on top....
yep got some of those parts and a public thanks for helping a nubie with solid advice and fairly priced prats. No gripe here but I bought a set...
acording to the engine builder, nice fellow presently tearing out his hair, the this was the first time the block had been bored. since then it...
this is socal you can't get board here. If tomorrow is the swap meet at Pomona there should be a ton of people there today setting up. 'course its...
ok quick story 325 hemi now in an eary dodge truck was running, but not well three rebuilds later it has 30 pounds of compression spray a...
Separate names with a comma.