The Jalopy Journal
5.2 (318 ci) or 5.9 (360 ci) out of a 94/95 dodge truck with the 46 rh trans. The truck engine has a rear sump oil pan and the ac compressor and...
I know its a bit pricey but the vise mounted turret style flare tool from eastwood makes some nice flares even in stainless.
Posted using the Full Custom H.A.M.B. App!
I found this site a few years ago. I know it is geared toward car audio but it still has a lot of useful information about automotive electronic...
Does your rack have the long or short pinion shaft? Had the same problem on my 37 dodge with the motor mount being in the way of the long shaft,...
Fatman M2 installed. Thanks again for all the information from your experiences with the M2. When I figure out how to post a picture I will put...
Yes 1.75 Wide. They have 8 leaves with a total thickness of about 2.062.
Putting a MII up front.
At least there isn't a lot of wiring to check.
Pulled the trigger and ordered the posies.
I measure 24.625
I put a spring back in and jacked it up to a point where the arch measured 2.25" and got a measurement of 17" up to the wheel opening. If that is...
Shift Quality & Linkage Adjustment (Session 279) from the Master Technician's Service Conference
I think the liquid in a gauge acts as a damper for the needle. Slows the movement down when it goes from one extreme to the other.
Also important to have a thermostat or at least some type of restriction to slow down the flow so it stays in the radiator long enough to cool.
I remeasured the springs, 53.250 eye to center bolt to eye. thickness of the 9 leaves is 2.125. I talked to mickey at Eaton spring. They do...
Thanks for all the information hoop98. I did do a bit of reading about leaf springs this afternoon so I could be an educated consumer. A real fast...
Thats some good info on Chevy springs. I need to find something like that for 37 Dodge sedans.
6-7 inch arch, is that with the 1400 Lbs or with no load? I've got to do a little reading about leaf springs, rate, frequency.
After reading eaton spring's explanation of re-arching leaf springs, mine do not look like they would be good candidate for the process. They are...
Judging by some of the modifications I've seen on this car I would not rule out the heat treating hack job. These are some fairly thin...
I have a 37 Dodge sedan with severely worn rear leaf springs. Completely flat with the shackle hitting the frame. Does anybody know what the stock...
Thanks for the replys and pictures. All the information is very helpful.
Any progress on the 37 Plymouth?
I saw a nice write up on modifying a slant six distributor to to work with the flathead, but I've got CRS.
Gotta have a mopar.
Thanks F&J, looking forward to seeing those mock up pictures and getting some actual dimensions of the spinde center to bottom of frame.
Dane thanks for posting the pics, thats a real nice looking truck. I have got a few questions. Does the truck frame have a hump in the front...
How do you like their kit on the 41 IHC? How much did it lower the front end? I've talked to them a couple few times and got information that...
Separate names with a comma.
The Jalopy Journal
