The Jalopy Journal
Thanks for the quick replies guys. Eventually I would like to build a custom steel body for my 32 chevy. Indy roadster style. Milford customs...
Have beer, will travel. Northeastern ohio I am a younger guy (35) and I would like to learn how to do custom metal working. I have electrical...
If you connect a 12 volt negative ground accessory to your stock radio, one side of the input jack on the stock radio could be connected to...
If you run 2 six volt batteries in parallel then it will act like a larger current capacity 6 volt battery. They do make a 6/12 battery that...
I am not sure if this is the right place, but I wanted to pass this along. The shop is in Beaver Falls, PA (far western pa)...
I bought some repop stainless from them for my 53 chevy. It looks good and fit ok. I have bought about $2500 worth of parts from them and havent...
Whole manual for a 53 http://chevy.oldcarmanualproject.com/chevyresto/53index.htm Chassis http://chevy.oldcarmanualproject.com/chevyresto/53025.htm
There should be some shapes on the bottom of the can that relate to the values and ratings on the side of the can. Each leg is a 'positive' with...
Ive seen bushings, gaskets and seals. The hard to find parts are the actual gears. Does anyone have a good source for those?
It is a cool place. Bought a few things from them over the years.
I have heard of the fuel boiling in the carb if there is no spacer between the carb and intake.
National Chevy Assoc has all 6 pieces for 263. Or you can buy individual pieces. I have used glass from them in my car with no problems.
There is a guy on here who used a Toyota Tundra truck axle in a 1930 chevy. It looks like a nice swap, kept the 6 lug wheels also.
In 53 they had 216 straight 6 engines. GMC made up to a 478 v6. There is a newer straight 6 that has good power in some OT Trailblazers.
http://www.jalopyjournal.com/forum/threads/1950-chevy-216-to-235-swap-bus-coupe.318742/
Looks like it will http://www.jalopyjournal.com/forum/threads/1949-chevy-reaer-end-tranny-swap.271045/
If you change the transmission you have to change out the rear end because of the torque tube. The first 283/4spd was in 57, so go with...
Pull all the fuses. Replace 1 each night.
Does anyone know a serious collector of this kind of stuff? I have a rare piece that I would like to go to a good home.
Are there any plans for the 2nd annual show?
If its that far gone, just use the sedan body.
Here is another solution. Shameless plug for a hometown business http://www.antiqueautobattery.com/accessories.html
I am cleaning up the garage and have some plymouth parts that need a new home. Parts are all driver quality and best offer. I can provide...
Speedway sells a 6v low pressure electric pump. Just plumb the new pump in parallel with the existing setup.
Indy is having some vintage racing all weekend. Wright Patterson AFB museum is near Dayton, OH
I am going to try and make it. I would love to see the pre-war cars run.
Thanks for bringing this feature back.
Lookin good Gary
National Chevy might be worth a shot. These fit 49-54 Chevy Passenger cars. Accelerator Shaft Floor Seal Set #783- 2 cork and 1 felt - $6...
Well.... You could use a 6 volt relay to switch in a separate 12 volt battery. Or you could try and build this simple circuit.
Separate names with a comma.
The Jalopy Journal
