The Jalopy Journal
trulyvintage - You will be able to set up indoors May 16th, noon-5pm. As may spaces as available at the time you want to purchase those spots,...
4 months away. Make your plans, come and sell or just come to buy. See you there.
[ATTACH]
The spring AACA swapmeet at Hawkeye Downs will be held May 17th, 2025.
Mac - Thanks for the good information. Unfortunately, most all of my builds are closed drive. Is there a good way to identify the truck 51-52 and...
Banjorear - I’m sorry I didn’t explain every bit of knowledge/experience that I possess. I have “fooled around with one”, actually a few of these...
Bored&Stroked - Well, I do have a lot of equipment but, unfortunately not a surface grinder. I’ll just have to lap my shims. What grit should I...
So, has no one here annealed the gears, to remove some brittleness? Also, when re-bushing second gear, do you concern yourself with the little oil...
Well, I ordered and am waiting for “The Ins and Outs of Early Ford Transmissions Book” by Mac Van Pelt. It should be here in the next couple of...
I have 24 total transmissions. Some side shift, some floor shift, 78 cases, 48 cases, one 18 case, etc. Plus misc internals and extra trans parts....
This is all very good information. Automotive Stud - I didn't know about using later '50's gears but, why? Did the material or Rockwell hardness...
Let me start out by saying I have searched and researched this site and the internet. I have both the Vern Tardel and Max Navarro books on the...
Mike, thank you very much. That is the exact type of information I was looking for.
That's what I was afraid of. Bruce was one of the few people that could and would answer technical questions with fact information minus the...
Nothing? Nobody has any information or references toward technical data?
Yes, steel but, what steel? I guess I should have been more specific. What grade of steel, A572, 1045, 4140, etc. No, I'm not going to make new...
Can anyone tell me what material ‘39 Ford transmission gears and shafts are made of? Also, what Rockwell hardness they were originally hardened...
Sweet, thanks. That’s a valuable page of information.
Can anyone identify what this trans adapter fits? I know the transmission side is ‘39 Ford 3spd trans but, I haven’t been able to identify the...
Is there anyone in Eastern/Central Iowa or Western Illinois that does gauge repair? Speedos, temp, oil pressure, etc. I would much rather...
Briggs, yes, I own one. Cunningham, not ringing any bell right now. I’m not looking for some “standard” measurements, just actual measurements of...
Nothing? No measurements, no information, no help? I guess if our Model A club every starts meetings/events again I’ll just take a tape measure...
Great idea. Within this group don’t we have every model of 28-31 Ford Model A? If we were to put together a standardize batch of measurements,...
I’m looking for a source (internet or book) for definitive information on Model A door measurements for all models and years. Any help or...
The Cedar Rapids swap this year(2019) may use part of the track but, is adding more area near the car corral. The fairground board keeps raising...
Figured it out. 1931-33 Chevrolet 1 1/2t truck. Now, I'm looking for 2 of them, any ideas on where/who to ask? Sent from my iPhone using The...
Anybody? Sent from my iPhone using The H.A.M.B. mobile app
The slots around the top are very similar too a 1950 Plymouth Suburban air cleaner but, those are dome topped and do not split in the center like...
I don't have them, missed out on eBay. Don't think they're oil bath, looks like screen and filter gauze material. Isn't 2 1/4" a single barrel...
Separate names with a comma.
The Jalopy Journal
