The Jalopy Journal
Awesome Jerry! When are you going to show the car again?
Cool, thanks!
I plan on getting a complete harness for my 65 c10, I don't want a universal kit. Painless is too expensive, I was looking at an American Autowire...
I don't have a problem with leaf springs, I just prefer the trailing arms. The NASCAR trucks run a very similar setup. There's a guy at the local...
You can't beat the trailing arm setup, leaf springs suck! And besides you can buy 5x5 lug rear axles from Moser for about $250! I'm running a...
I kinda dig the rake!
A '67 turn signal switch which came with all new wires, wired into the '65 harness
I have a '67 c10 automatic column in my '65 Chevy c10, the plug for the column is a little different. I matched all the colors with one another...
Thanks everyone for the help. Ended up just buying a TCI flexplate
Yeah, that's what I'm thinking. I have a TCI converter and the flexplate has two different bolt hole sizes and the bolts wouldn't go through the...
I think most of them do, but there's an option for a 350 in the computers at the auto parts store
Yes I left the same starter on when I switched from flywheel to flexplate. I bought a new starter and looked it up under an 80 c10 and that same...
Not sure, it was a cheap $20 flexplate. I'm not sure what diameter the flywheel was, sold it with the 4speed. I did run this same motor in my old...
It's definitely a 350, is there a difference between 305 and 350 starters?
I bought a new flexplate at Advance Auto Parts part # fra-100 it's has 168 teeth. I was running a 4 speed and swapped to a th350 and my old...
So all starters with staggered holes are for 168 tooth? I looked up the part # on my flexplate to confirm its a 168 teeth. My old starter has...
cork or rubber gasket with an aluminum pan? Also any tips or trick to get it to seal well?
Do you know what PCV valve y'all used?
[ATTACH] [ATTACH] What's everyone's thought on running a PCV like this?
I was running a 4 speed and recently went to a th350 and my starter worked fine before the swap and I wasn't running any shims on it. Once I did...
Awesome, thank you.
I'm having a set of wheels reversed and chromed, Wheel Smith won't use the hoop on my wheels because they're spot welded on instead of riveted, so...
Awesome thanks, I'll try it with sand.
[ATTACH] Is it possible to make a bend this sharp with out crushing this 1/2'' tubing? Not sure how thick the tubing is, but here's a picture to...
[ATTACH] I think this is my favorite shot of both cars, so much color! But there is a Corvette or something ruining the photo haha.
[MEDIA] I'm still having trouble uploading this video, but here's the link to it on YouTube. Full video and better quality.
Hey Jerry are you going to make it out to The Invasion in Deep Ellum or Pistons and Paint?
I dropped it a couple times on a piece of wood and it fell right out, thanks.
Separate names with a comma.
The Jalopy Journal
