The Jalopy Journal
Thank you, I'll give it a try.
Thanks Jim. I found the same one on ebay. It sure does look the same, minus the pushrod. Shows its from a 72 to 76 Ford F250 RWD single piston...
I was able to locate a casting number of 29903.
Thanks, I’ll give it a look.
Sure wish it had some part numbers on it.
In need of a replacement manual master cylinder with the pushrod and was hoping someone could help identify this model. The pushrod appears to be...
Found the correct seal at RockAuto.com. National Part # 7692S Thanks for the help.
Inside diameter is 1.49 inches and outside diameter is 2.36/2.37. Thank you.
Both. Thanks.
Unfortunately, it is not in the original car. It is in a 1940 Ford Coupe, behind a 289. I will have to get the measurements. Thanks.
I have ordered on from an online trans shop and one local. Both are wrong. Main Case is T10B-1 and Tail Housing is T10H-7. 28 spline output shaft....
Separate names with a comma.