The Jalopy Journal
Any ideas where I could find these?
Thanks for the thread, looks fairly easy
Is there anyone that could do a headlight drop on 36 Ford original headlights
I'm thinking of putting the spare tire wheel and ring on my 36 ford coupe but the tire and rim seem way to heavy , has anybody used just a inner...
Did you have the same problem before you changed the disc and did you replace the pressure plate also?
I have a 36 ford with a 48 merc flathead and a t5 transmission it has the original pedal setup with a shaft coming out of the bell housing , the...
1936 Ford coupe interior winnshield trim , should the hinge openings face in or out
That makes sense, I'm using a vega steering box and I am not using the column lock , I think I'll just find a longer universal joint to connect...
The pinch bolt appears to be some kind of rivet head looking at it from the bottom but there seems to be threads looking at it from the top, I...
Thanks for the information
is it possible to slide the steering column on the original column drop , I need to get the column about an inch closer to the steering box
Thanks
on a disc drum master cylinder which bowl feeds the front discs the large bowl or the smaller bowl?
Gauges are new and car is 12 volt, I grounded the sensor wire and the gauge went full up so I know the wiring and gauge are ok, I would like to...
is there a aftermarket temp sensor part number for a 48 merc flathead 12 volt, Is there a way to check one of these?
Yup that's what I have, those cutouts really look lousy from outside the car though
1936 ford 5 window coupe, I only noticed this problem after the car was complete and it shows up like a sore thumb, there are cutouts in front of...
Is it possible I have them on backwards? Sent from my iPad using The H.A.M.B. mobile app
The inside windshield molding on my 36 coupe has 2 cutouts in front of the hinges they are facing out and look terrible I have noticed some on...
Sounds like a good idea, thanks
Thanks, looks like po put them in wrong with bolt going down and the nut on the bottom
does anyone have a picture of the correct way to install motor mounts and bushings on a 36/48 ford flathead
Thanks for the info, I installed the hose fitting looking for something a little better, I think I might drill and tap an outlet like one of my...
is it possible to use the 48 flathead truck water pump with the heater hose outlet on the 48 car flathead which does not have that outlet?
Wish I had seen this before I put all the front sheet metal on the car
putting a heater in my 36 Ford with a 48 Merc flathead, tried installing the heater hose adaptor in the lower radiator hose but can't seem to make...
Thanks for the info
Separate names with a comma.
The Jalopy Journal
