The Jalopy Journal
I have a 355 sbc with a Howards Rattler Cam 525/530 lift, 226.6/234.6 dur. @ .500, /1800-5600 rpm band, AFR 195 heads, TH400 trans, and 373 rear...
Thanks for your reply. Would the standard work for a 500hp roller cam?
Thanks fof the reponse It is externally balanced. I have a 355 sbc with a Howards Cam in it, 525/530 lift, 226.6234.6 dur. @ .500, /1800-5600...
I have a zz4 350 sbc casting #14093638. I will be mating this to a th400 trans. My old flexplate is 168 tooth, 4.125" dia but the crank hole is...
Happy Thanksgiving all. I just had my engine rebuilt and can't install it until Mar-Apr. In the pole barn (not heated) under a breathable cover....
Thanks for your input, it's much appreciated. I'm running Cherry Bombs right now when I'm not running open headers
Thanks. Do you have any suggestions? Can I run breathers in the valve covers to some king of catch can? But then I'll have to run some type of...
Thanks. Would you have a photo of that kind of system?
I just picked up my 500hp 355 SBC. The engine builder said I should go with a Summit evac kit venting to the exhaust rather than the pcv to the...
I have a sbc 355, 10:1 Looking for head and cam combo to get me 425-450hp, power band: idle-5500 rpm. Good lopy sound, very snappy response. I'm...
Would like your suggestions. I have: -Gen 1 SBC 355 10:1 compression -Single plain with dual Quick Fuel 650's -Dart Iron Eagle heads with 215cc...
Running Comp Cams 986-16 322# spring rate that Comp Cams recommended.
Thanks. Will this be a better way to go or keeping my current cam and buying budget 195cc heads
Trying to make things work with parts I have or with as little additional money as possible. Not being cheap, I just dumped a lot of money into...
Figure compression about 9.8:1
So what am I actually losing with my setup? Comp Cams recommended the xe284h cam with the dart 215cc heads. Would the gain be worth the change....
Cruiser with limited strip time. Like to get tossed back in the seat cruising too. Running motor through turbo 400 with shift kit to a Ford 8.8...
Thanks for the response. Looking for 425+ hp and getting all components to work with each other
I think I've mixed and matched my way out of power. Here's what I have: Stock bottom Gen 1 SBC 355 Flat top pistons Dart Iron Eagle 215 2.02/1.60...
Thanks this helps. I just need to see a close up of where the rod connects to.
Thanks, if you want to sell the door knob rods let me know
I'm to the point of installing the interior door panels but I stupid stuck. It's a 1951 Chevy Styleline Coupe. When I got it the rod that goes up...
Bought the car with locks in but no exterior handles attached or door knob rod. Can someone please tell me where the rod from the lock mechanism...
1951 Chevy Styleline. Gas gauge only registers 1/4-3/4. Tank is full but won't go past 3/4. This is second brand new 30 ohm sending unit from...
WTB- Vintage water slide decals. 1950-1960's speed shop, equipment, strips, etc. Going on the quarter window of my '51 Chevy Gasser style coupe....
Thanks
Anyone know what seat belt length I would need for a 1951 Chevy Styleline coupe? 60", 74", or 90" Regular sized guy with seat all the way back....
Separate names with a comma.
The Jalopy Journal
