The Jalopy Journal
@J.Ukrop get a load of this
Not without bending the top steering arm slightly
Is the pedal assembly moving freely? they can bind up if never oiled. I'd also be tempted to try flipping the bell crank up the other way to...
That axle taper looks pretty beat, I'd be lapping the hub to the taper with some valve grinding paste before installing. As is, it looks like...
The posts look extended to me which is a strange modification, [ATTACH] here's a pic of my standard height posts for reference [ATTACH]
If the tack strip is going to be upholstered you could possibly use something like nylon bar stock
Open up the retainers you're not going to use to fit over the bearing, acting as a spacer. When Ford Australia started using the 9" in our Falcons...
put a socket and washer over the end of the bolt short enough to leave 3 or 4 threads exposed, screw the nut back on a tighten. Same method you'd...
Just picked up this B trans for my roadster, hope to use it behind the B banger, will this trans bolt to the A flywheel housing or will I need to...
Thank you for the info, it is indeed a speedway engineering piece. I don't like my chances but I'll see what I can turn up down here.
I don't have any A rear ends apart but I believe this is even smaller than an A, ring gear measures 7-1/8OD 4-3/8ID
The width is spot on for the 36 rear ends I have, diameter is the issue, this thing is tiny, smaller than A model. Other problem is even with...
That wide five looks like it could be one of the hard to find 3.5" wide V8-60 ones
I gotsta know @anthony myrick wouldya?
They're the most common 16x4
Got a pic? @panhead_pete they're all quite visually different
Picked up this quick change a week back for $100, hoping it was early ford compatible, unfortunately it's midget so will look at selling it on or...
https://www.jalopyjournal.com/forum/threads/rare-ford-wide-5-15%E2%80%9D-x-6%E2%80%9D.1302718/
windshield defroster, possibly, couple of wraps around each leg of the intake should do it, and nearly invisible from a few feet....
Missed out on this at the swap this morning, pretty wild and corroded [ATTACH] [ATTACH]
Try posting in the monthly banger thread @Retson the Racer any ideas?
Here's a few [ATTACH] [ATTACH] [ATTACH] [ATTACH]
[ATTACH] I got mine from Petes over on the East coast of Australia
Haven't posted in some time, life etc. Starting to turn tools again though, have pulled the roadster down to start fitting the necessary things...
if that fails you may be able to use wedge/tapered washers on the bulkheads
@VANDENPLAS will know
@patsurf generator is belt driven from the back of the supercharger
[ATTACH]
Viton seals are more forgiving if you're a little heavy handed on installation. Teflon seals work well but can crack or chip easily.
No heat, in the press 2 inch intervals. If there's a crack or thin spot you'll find it, but better in the workshop than roadway.
Separate names with a comma.
The Jalopy Journal
