The Jalopy Journal
I think the choke is less then 1 amp
im sure somewhere in this thread is the answer im looking for.... where is the best place to pick up power for the electric choke? I have a 9 t 3...
Bringing up an old post Can someone provide a part number for the jeep tie rod end?
getting ready to run fuel lines on a hot rod , couple of questions should the lines be 3/8 hard lines or? Also where can I purchase solid fuel...
Going Bob? Taking the new ride? Would really like to see it,!
Interested, what are you thinking ? Where is the starting point?
I checked power at the relay and am not getting any. the fuse is good. would it be a loose wire on the fuse block?
Question on a painless kit. I’m having problems trying to troubleshoot a non functioning horn Fuse is good and has power on both sides the fuse...
Would a AR170 cross over to a hella 87152? I’m trying to find a horn relay for a painless wiring fuse block?
[ATTACH] [ATTACH] [ATTACH] [ATTACH] I need some help 1941 ford pickup with a 283 Chevy, walker radiator, straight axle, stock frame. I am having a...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Pulling up an old thread I know, but need some help. 1941 ford pick up with a 283 Chevy,...
ok I need to replace the pitman arm on a 59 Willy’s Attached are pictures of the arm I want to use. You will see how the tie rods are not parallel...
are the car and truck radiators the same? im getting ready to replace the one I have in the truck. looking at US Radiator, Hoffman, and walker
Thanks!
Color is a custom mix , was really hesitant to shoot it at first but once it layer on it looked good
not that im against spending the money, I just figured I would look into this motor and see if it would work.. currently running a early 283 in...
to answer the first question, why not get a decent 350? that was the plan until I started seeing cost... (Im a CHEAP ASS LOL) I have this engine...
looks like an early 90's motor, it has aluminum heads not sure what they are yet the only thing I have found stamped on the back of the head is...
I have a LT 1 engine I am contemplating putting in a 41 for d truck. what issues will I run into on this install? its a carburetor motor , will...
Very nice!
Right now I'm kicking around walnut. Any recommendations?
im looking at changing the wood in the bed of my truck. It is currently your standard oak wood clear finished Wondering how it would look if I...
Let me try and answer a few questions asked above The combo is a 350 motor , 350 trans combo, at this time I'm not sure of the rear end ratio. The...
i have a 350 chevy in a 59 Willis panel. The engine has a ca in it not sure what it is exactly , it has a larger race carb on it right now. I had...
Here’s where I’m at
How do you wire this using a 1 wire alternator? I ran fused power from alternator to #30 on a relay then from # 87 to choke Checked power and...
Even if the paint is matched now, how will it look 6 months from now? I have a truck i need to take in for repairs due to a canopy hitting it at a...
Jumping in here, I'm also looking for a painter in the so cal area. Los Angeles / Orange County area. Any recommendations?
Separate names with a comma.
The Jalopy Journal
