The Jalopy Journal
They have a rounded identation like they are meant to be mounted on a ball shape.
Headlight question I have a pair of BLC 682 headlights and they seem to be both made for the same side of the vehicle. The opening on the bottom...
I'm pretty sure that car has a closed driveshaft so there is no ez replacement.
I have used the Chassis Engineering bolt ons and would highly recommend them to a novice builder.
I bought a power window kit from them. Total crap!
I'm swapping a T-5 into my '64 El Camino and will need to shorten the driveshaft. What I need to know is what slip yoke to use for the t-5. The...
Past Gas!
The best solution to your problem would be factory type overdrive trans. It would still give the little six the advantage of the 3.91 gear and...
Hammer,dolly and weld is best. If you decide to cut and patch you can use one of those step or unibit drill bits to cut nice round holes where the...
The old car hobby is like marriage. You get in for love not money. Seldom do you get both. So, do what you love and don't sweat the money.
A good idea anyways.
The nailhead is long but narrow. It should fit the '38 well. One thing that may be a problem is the starter and the stock steering box could...
Thanks for the rapid response. The HAMB brain trust is on the job.
I've just aquired a step down Hudson but have not gotten it home yet. It is a '53 Super Wasp coupe.It has been sitting in a farmyard for a long...
That was a weird one. Good job getting it figured out.
I'm holding one for a guy right now. He keeps telling me that he's sending some money. It's not looking good.
Those air cleaners look restrictive. Could be causing you to run lean and that equals hot.
Well,I'm 55 and think I've done my part. My son who is 33 grew up fully immersed in the car thing. He always drove fixer-uppers when he was young...
I was recently given two Ford 8.8 complete rear ends. They are both out of late Crown Vics and are really too wide for any older cars. They are...
If he is a good friend, just help him make it as good as it can be within his vision of the finished product. There are a lot of us here who have...
These people are politicians and numbers count. The more people that you get get at that meeting,the more impact you will have. Good luck.
I just had my local NAPA store make one for me. They used 3/16 brake line(double flare) type fittings designed as hydraulic crimp on ends for 1/4"...
I recenently had this same problem,but with a different combo. I solved it by fabing some leftover mandrel bends from a set of headers I had built...
I had a similar problem with a set up alot like yours. It turned out to be too much fuel pressure causing carbs to slowly flood. A fuel pressure...
Scrap that crap and copy Rusty1. You won't be sorry.
All I can say is that when Squirrel posts, I read. I've learned alot. Keep it up and thanks.
You have approach it and ask "Who's there?" Then wait for the punch line.
I think a "pusher" type school bus chassis might be a good possibility for you.
I was about 11 yrs old and my cousin Billy who is about 7 yrs older than me comes by the house with his barn find hot rod. It's a 28 A coupe with...
Looks like Jorgensens in Lisbon ND.
Separate names with a comma.
The Jalopy Journal
