The Jalopy Journal
Henry Steel price drop 40k.
$49,500
Price drop $50k
1932 Ford with a Ford motor!! This car was just finished with about 1k miles. It still needs the turn signals wired up. I just bought a...
That makes sense, thank you.
I moved the pump back by the gas tank and it did it again today. 3 minutes of run time and the fuel stops pumping until I purge it.
Thank you bud
I have a 1932 ford with fuel tank in the trunk and an electric fuel pump under the frame rail up front. After driving the car for 5 minutes or so...
I have a 1954 F100 3 speed transmission that I’m not going to use. I was told both the engine and this transmission were rebuilt but I’m using the...
Does anyone have an idea of what this spring is off of? I bought a Speedway 38” and it’s the same width as my frame. I’m looking for a wider...
I tried to save a buck and the rods look like plastic. They are also not the typical round with flat edge shape.
All it has to do is look cool!
Fellas, I need a little help…. I tried to save a few bucks and bought carbs off of EBay. I didn’t realize the carbs had the “ball sockets” type...
Can someone help me identify this carb? I think it’s a Holly 97? It has a “Ford” and “1-1/16”” marked on it. I don’t want to order the wrong kits....
I installed a 1953ish F1 steering in my 1932. My problem is I have the “ball” type connection on my steering arm and a ball joint at the front...
I have it jammed in a 1932 3 window. I am in San Antonio TX
I never even thought of that, thank you.
Gents- I want to install a T5 (world class) on my 239 Y-block. Will the current 3 speed clutch, pressure plate and release bearing worth with a T5...
Got it! Thank you guy's for the advice, I appreciate it.
[ATTACH] I was looking for something more like this one that will fit the 239 Y-block
Fellas - I am shoving a 239 Y-Block (1953 F-100 I was told) into my 1932 3 window and need a little more room for the oil filter due to the F100...
What is the length of the y block from the fan to the bell housing? I think my blower snout is about 7-8” from the front of the block. Without it,...
Thank you for all of the advice fella’s!
Can any tell me how deep a Y-block truck pan is? I currently have a small block Chevy and lowered my car and the oil pan is far too close to the...
How did you extend the shaft through the frame? I need to extend mine due to the boxed frame as well as the hair pins. Do they make an extension?...
Thank you very much fellas! All great information and I’m going with the 1950 steering. Based on that last picture I am worried how this will...
I have a 1932 3 window and desperately want to get rid of the GM steering column. I was looking for a 53-56 F100 set up but haven’t had a lot of...
Thank you fellas.
I have a steel 32 3 window that someone back in the day filled the cowl. United Pacific sells a weld in vent assembly for a 1932 closed car but...
Separate names with a comma.
The Jalopy Journal
