The Jalopy Journal
There is thread about using a gain control with RCA jacks to a power amp, and then to your speakers to basically use your phone as the source but...
I have the same set up. You can do just about anything you want but if I recall, I used a bolt and some RTV, no issues this far. You could...
So, as it turns out, my buddy had flipped the wires at the tail lights and in fact the signal/ brake feed should be the short filament in the...
yeah, i'm about to loose my mind and rip it all out. I can now get all the signals and brake lights to function correctly but if you press the...
so shame on me for not researching wiring harnesses before I bought this, but, the headlight switch is new and is a GM style, plugs into the...
I am trying and almost there, to install a speedway 22 circuit wiring harness and integrate it with the original column and signal switch in my 56...
I actually cut mine and was able to pull it away from both ends. I’m sure there is a much less aggressive way though
I did, no problems with hood clearance but it will depend on how tall the radiator itself is. I would measure mine for you but my car is half...
more progress the last few weekends. Need to get the rear inner quarters replaced and a patch in the trunk and I should be ready for quarters and...
Ah, that makes sense. I guess I should not assume the frame had the integrity to keep it all in line. Glad someone mentioned it as I'm pretty...
Looks good. I am curious why the need to jack it up on suspension components rather than the frame when lining things up though?
more progress on my car this weekend. just about have all the repairs done so I can start installing inner rockers. I may have asked before but...
yeah, that whole front area around the toe board and door post was all rotted out.
Getting there, thanks. Made some more repairs and very close to being able to start installing the inner rockers
not really. this profile pic is about as close as I have. I do still have the cut pieces sitting in the garage though.
Texas57, thanks! I appreciate it. Any insight on the construction is appreciated. As you can see in that picture, there's not much left and...
sorry forgot the ima sorry forgot the image [ATTACH]
Ernie, I'm in deep in mine, I know this is an old thread but hopefully you're still on this. I read what you had about the forward section of the...
Mark T, I'm replacing a lot in my car and found this thread. I'm trying but cant tell exactly how far ahead of the first brace the inner rocker...
I doubt it. my buddy sent me this link, I think I have enough solid material left to scab these in and tie it all together....
ha ha, well, I won't lie, I'm in over my head and way outside my comfort zone, but grab the bull by the horns I guess.
should I be questioning my sanity?
more progress this weekend, quarters are cut out. Looks like I will need inner rear quarters now. I was hoping to avoid that but am not...
Passing this along for anyone it may help. I talked to EMS and they said to install the quarter first, then the rocker will overlap it. There is...
Gotcha, I have no good metal left there, ha!
ah crud. did you use inner rockers from EMS or were your originals intact?
well dang... I guess take comfort you're not alone... I reached out to EMS and they said they would look into it and get back to me. Kind of a...
Texas57, I have the rear quarters too. that piece looks correct, although it may need to be trimmed to fit where it meets the rocker. [ATTACH]...
I hope you guys can help me, maybe EMS guy can chime in on this. I know I'm a rookie but I feel like I'm missing something with these...
Ha ha, I think my job gives me more grey hairs than the car, just wish I could find more time for it, I'm starting to itch to drive her again.
Separate names with a comma.
The Jalopy Journal
