The Jalopy Journal
Will this 15V voltage regulator "work" on my ‘56 Ford Fairlane car, 292, automatic, no air, all manual with an original generator? Or does it have...
No, its not necessary when using with the pertronix electronic ignition.
Thanks... Im going to switch out the pertronix back to the original to see if that works. Im also wondering about a bad ground somewhere maybe......
Yes distributor was removed and switched out the points with Pertronix ignition and a Pertronix coil. I may switch back just to see if that’s the...
Ok, I did the compression test and here are the results: 1: 135 2: 135 3: 135 4: 150 5: 150 6: 145 7: 135 8: 150... Then, I squirted some oil in...
automatic
Not a lot but enough that the threads are coated, the plug is wet and if I place a finger in the plug area I get a finger full... although the...
Engine does not start at this point, so the compression test will be on a cold engine. Will that affect compression numbers?
it was just a "top end" rebuild. Im not a mechanic-didn't want to get in too deep :|
Thanks, oil was on the ends of the plug as well... not just the threads, if my compression is bad, then where do I go from there?
Tried to start a recent rebuild of my '56 Ford Fairlane, 292 Y block, but it would not start. Checked the plugs and they have oil on the ends as...
I need two of these radiator side air deflection panels, or st least the curvey top part. See my current ones for reference.
Does the ball look like its setting deep enough in the push rod cup? Lash is set to .020 cold. I've been told the rods are too short as well.......
Any idea what year and model (ford, Chevy) these are?[ATTACH][ATTACH]
Hi everyone, I'm restoring my 56 ford town sedan and need a little guidance when it comes to dismantling the suspension. As you can see I've taken...
I have all the nuts off the steering linkage for cannot seem to separate the rods from the the arms. Also separate the rod end from the spindle...
So how does one remove the steering wheel without the special steering wheel puller tool?[ATTACH]
Looking for source recommendations on replacement body panels for a 56 ford airline. Im thinking of ordering from EMS Automotive... anyone ever...
I need to weld my 56 ford fairline frame front cross bar and want to purchase my own welder without spending a fortune. What do you think of this...
Can't wait to start tapping into the knowledge here!
Separate names with a comma.
The Jalopy Journal