The Jalopy Journal
bump
[ATTACH] Cody cleaning under a 65 Elco.
[ATTACH] [ATTACH] This is what my 28 weights with a half tank of fuel. It's pretty much neutral without me in it....
When your hat blows off, you've chopped a little too much.
http://www.misschicken.com
My bad I was looking at the drawing instead of the picture. The cuts are off set in the drawing but center on the actual metal. Start welding!
I wouldn't think twice about using those plates. I would put the cuts opposite of each other (outer to the front, inter to the rear) and weld it...
[ATTACH] Like this? Send me a PM.
I didn't have a custom axle made. I pulled another short side axle and cut the rear end to fit it. If I break one I can find another one anywhere.
Used it last night! It works great. I use his clears also.
351 Cleveland 4V open chamber heads for sale with comp cams springs. Heads redone about 450 miles ago. $500 or trade for? Also have some high...
[ATTACH]
Chip board I think?
[ATTACH] 4" drop axle in front coilover in rear.
65 elco in progress...
[ATTACH] [ATTACH]
[ATTACH] I used 1" square tube and a ribbed roof. Do what works for you.
It's not crazy but it's a nerf bar. Merry Christmas!![ATTACH]
Ok thanks for the info.
If it's a matte paint job, couldn't you just wet sand the car with 2000 or 5000 grit? I used 3000 grit on a bike and it looked good for a flat...
Or you could put it in a plastic bag then put it in the box.
[ATTACH] [ATTACH] My Great Grandparents 50 Olds
Here is a 47 Ford coupe with a Caddy engine. The man I bought it from said it had Zephyr gears in the trans., I don't know for sure? Needs roof,...
[ATTACH] About 4", not enough for a armadillo...
For corners I use a 1/4 thick pad that I wet sand with.
Thanks Pete! It's 5/8" stainless. Bending up the first side wasn't to bad the other side was a different story.
30tudor got it. The spare tire ring has a rib running all the way around it. I just cut the length I needed and made the stainless mounts. The...
Same here Pete, trim ring fronts, bobbed the front of the rear fenders and widened them 2". 28[ATTACH] [ATTACH]
Separate names with a comma.
The Jalopy Journal
