The Jalopy Journal
Interesting; always thought the stock grille looked out of place on the Cunningham '40 with the quads.
Sad news; RIP 34 guy.
Get a pair of the springs Posies use in their '33-'34 kit and make some new mounts to fit.
I used to acquire "in date" extinguishers from trade in equipment when the cities forgot to remove them (always took them out so the vandals...
Helped my buddy put together this yellow '29 back when we were kids. [ATTACH] Back before that I built a yellow T bucket. [ATTACH] And the...
What kind of special grille is in the plan?
Us an external charge wire as you are planning. Upgrade to 8 ga to suit your alternator output, and put the fuse on the battery end. If you are...
Shouldn't be a complicated deal. Modify a aftermarket car plate to work. Shorten the truck column, add a floor mount, lower bearing, and U-joint....
My buddies old race car has two 5 gallon jerry cans with the bottoms cut off and welded together and mounted on edge in the trunk. Red thing...
Yep, first thing we did on a friend's Buick was to make new rear spring mounts and put a regular rear axle under it. Then being it was in olden...
Isn't that big fuse intended to go in the main battery feed to the fuse panel. Usually located close to where it is connected to the battery...
https://www.murocmfgco.com/
Good looking nailhead; but unwanted things have a habit of getting in open spark plug holes.
You could also run it down the left side of the engine and then around and down the back with the start wire and connect it to the stud with the...
Back when you could find '32's in the junk yards I don't remember ever seeing one that didn't have a '32 axle; same with '32 frame hay wagons at...
Kinda going far afield. The alternator bracket is stock for a '63 Chev. '65 Chev use a different exhaust manifold and bracket; but still put the...
Have you tried it with the belt on; looks like the pump would swing out a ways further from the alternator belt. [ATTACH]
Pull the pumps, poke around, dislodge, and remove all the rust, casting sand, and core support wires that maybe in there.
Lots of back-in-the-day pictures around of race cars with tow bars made from Ford front wishbones. Here are a couple of a typical wishbone tow...
Pump to high? Doesn't quite look like a factory bracket.
End of a '32 axle in comparison to your '33-'36 axle. Note the axle is taller than the perch boss as previously mentioned along with the distinct...
Thanks for the link; it looks like a good machine; but the 110v model is "sold out".
Maybe try this; I just joined several with no problem (other than spending time reading a bunch of interesting posts). Here is a sample of how...
Oh, I see the picture of the footnote now; must have buzzed past it when I was looking at your Hollander book pictures earlier.
That sounds promising. I noticed the links in social forum to the "good" conversion kits seem to go to out of stock or error pages. Anyone have...
If you click on the little square thing on the far right by "private" ; it should ask you to join group. But; yeah, the social groups don't seem...
Upholstery Social Forum is the second to the last under the "art" category. [ATTACH]
The tail light holes will be different and the side trim holes maybe too depending on the year of the later fenders.
Wondering if anyone that has switched to a servo motor drive would compare the feel and controllability as compared to a regular clutch. I'm...
Maybe I missed it in an earlier post; but what are your plans to soup up your Willys mill? It has been fun watching your car develop in your posts.
Separate names with a comma.
The Jalopy Journal
