The Jalopy Journal
yes the earlier 302's that had the water passage directly above the cylinders .I decided to go ahead and do it
Decided to go with some aftermarket Edelbrock 5023 street heads. Instructions say to drill 1/8" steam holes in deck on cylinders 1 & 5 using the...
Yes thank you, I see that after searching more on the topic.
Yes thank you that is the plan. I'm wondering to the heads have roller rockers with hydraulic flat tappet lifters, not roller from what I...
Update. Pulled the head did a leak test with head out. The zero compression # 2 cylinder had a bad intake valve leak ran out as fast as I poured...
pretty sure there hydraulic
Found my zero compression source. After taking off the intake manifold I decided to hook up the compression gauge and try it again. While...
thanks
pulled the intake will check with pressure tomorrow. I thought the anti freeze looked cloudy when I drained but now with intake off can see...
Yes I think 1981 they changed
no leak down, direct hook to compressor with gauge
Unless its doing what AnotherCarGuy said maybe pressure pushed the valve back to seal
You can see by my reading it worker on the other 7. I still think when I did put pressure to the cylinder the first couple times I could hear a...
Put 50# pressure dropped to 38# after 90 minutes
rotated engine looks like same movement of rocker as other ones
Correct HotRod
The idea you mention of air closing valve crossed my mine, because when I first put air to the cylinder the first 2 times I swear I heard air hiss...
The first couple times I tried it yesterday I thought I could hear air slightly but couldn't pin point then nothing. Also when I first did...
I just run the distributor around to #2 so both valves are closed, can wiggle rockers back and forth slightly. Hooked up compressor direct with...
Purchased restored 1965 Mustang with 1971 302 rebuilt 19000 miles on odometer, Started and ran good except ruff idle which being cammed though...
Yes came from Inline Tubing. push rod is correct length , double checked it with my MC gauge
Its right now very little pressure. I backed the adjusters off some help but then my one back brake locked up when braking, so ever though the...
Changed my manual drum brakes over to 9" booster with dual MC. Installed different distribution block for the dual MC lines, MC to booster rod is...
Changing manifold to upgrade from 2 barrel to 4
Thanks for the information
Thanks seen that in some researching I did. I suppose if it does Ill plug the back draft hole and go with valve cover pcv
Edelbrock 2701 Performer. It came in a package kit
Changing to new intake manifold and carburetor on 1966 SBC 283. It has the original pcv system it came with(attached pictures) with the baffle in...
Looking good, what alternator mount did you use? I have the mount on the exhaust manifold on my 327. Want to go to different exhaust manifold but...
Separate names with a comma.
The Jalopy Journal
