The Jalopy Journal
[ATTACH] [ATTACH] [ATTACH] I'll play. My 1948 F3. Channeled 4.5 inches, zee'd rear frame and notched frame for the front axle to get it down....
Count me in. Busted ass all winter to get my truck done in time for it but I don't think I'll quite get it done (ish enough).
Looking forward to it!
A2B, nice work. Im not understanding your vacuum source though as exhaust would be positive pressure not negative.
I went back and you are correct. Two of them were 52" and one was 52.5". I must have missed it the first time through.
This is a great point, and it would probably chew up the tail shaft bushing. Might just need a slightly shorter driveshaft. Wonder if all three...
One of my favorite threads. Any updates?
Looks fake to me. Rear door?
I had a long winded reply typed out but after re-reading this whole thread I think everything I could think of has already been mentioned . Is...
IF you really want to run an enclosed drive AND you understand that it entails more than simply buying the trans then it may be worth the money...
I always try to stick with whatever the product recommendations are. With the exception that I always at least lightly sand between primer and...
I took out a good sam membership several years ago primarily so the wife and kids would have something. We never used it so I was just about...
Need to finish the wiring, build a set of running boards, wood floor in the box, address some minor front suspension stuff, finish the interior,...
What causes metal to shrink over time like that?
[ATTACH] I believe you are correct in some cases. I seem to remember reading that the "early" T4's maybe didn't have the bump. Mine did have the...
I bought a t4 by accident once, it didn't have the shifter installed so I didn't catch it until I got home. It was cheap enough that I wasn't...
What seems to be the limiting factor that doesn't allow it to go over 45? If it's rpm a T5 (or any overdrive trans) wont suddenly turn it into a...
Assembling some freshly painted parts..... hopefully on the road this spring.[ATTACH]
What's with the big chrome shield? Alternator belt?
One more vote for metal. Since you are asking I am assuming that you don't have a ton of experience with body work and while I am at best an...
[ATTACH]here ya go. I'm running the same set up.
That's what I try to do. Clean the rust up as best I can and then treat it with a little ospho. Especially if you can't get at all of it, like...
This is awesome. Nice work
Heck yeah! Why not give it a shot? Do you plan on pressure testing it once your done or just send it?
Nvr mind just reread original post. Not overseas, scam.
Thinking about this for a minute. Do they actually need this info for traceability in case it turns out your shipping something illegal? I have...
No way man.
Is there an intent for the current "non-traditional" topics that currently get a pass (t5 transmission, disk brake conversions etc) to be shifted...
Looking forward to it.
Just got home. As stated lots of people and vendors. Took me a couple hours to get through. Seemed a mix of race stuff and "current motor" ( sbc,...
Separate names with a comma.
The Jalopy Journal
