The Jalopy Journal
I actually rough reamed them then honed them to speck
I bought new guides and they have the holes in them
I have a 777b solid lift cam, isky says power is 3000 to 6000 but recommend a 2500 stall with 373 gear, I’ve been reading you need 500 rpm stall...
I’m running the 7:00R -16 auburn diamondback on 1935 ford wire rims with radial tubes and I run 36 psi in them cold, seems to work well for me on...
Thanks everyone
I plan to ream the guides to have 2 to 3 thousands clearance on the exhaust side, and wasn’t planning on seals on them just the intake ones reason...
I ordered new guides from hotheads for the 241 and they have the holes , trying to decide if blocking them with the locator washers is ok
I’m rebuilding 241 hemi heads, my question is the exhaust valve guides have small holes in them to allow oil to lube the valve stem, and with the...
What are you guys running for clearance on int and ex valve stem to guide Id on 241 hemi naturally aspirated with 10/1 compression ? Thanks for help
32 all steel,392 hemi, stainless headers and exhaust, electric cutouts,400 turbo,9” ford rearend
Looking for a good oil pan for 241/270 center sump oil pan , whatcha got
Had racer brown do a regrind of 420 lift on my original hydraulic cam
Thanks , I wasn’t sure hot got a plug to go with
Ok hemi guys, I’ve looking for the best spark plug option to run in my 10/1 compression ratio 241 iron head hemi, I’m seeing it’s the short plug,...
I found one on flea bay , thanks a 6 cyl dodge fits
I want the cool factor, going in a 1936 ford pickup , thanks for the info
Anyone got a single wrist pin bushing for a 241 hemi, I have one damaged to replace , or do any other ones out there cross with it , 1953 model...
I thinking of running 3/2 barrel carbs on a 10/1 comp stock valve 420 lift cam set up . will 3 hollley 94’s be too much ? Anyone got a jet and...
I bought the ARP’s to use in the build also getting new head and crank bolts from hotheads also
Thanks good to know , name of vendor ?
Comming along but slowly , block is getting an .030 overbore this or next week, then measure and order pistons when I get it back
Not yet been looking on line , but not finding them
Where are you guys finding new rod bolts for the 241 dodge hemi , are they available or what do I use ? Thanks
I see , I’ll look into that , thank you
Interesting thanks man
Any one got photos or info on installing air conditioner compressor on 241 dodge hemi, hot heads show brackets to use with their conversion cover...
I thought that was for the 315 and 325 ? Will it fit the 241 ?
Rebuilding a 241 dodge red ram hemi and all I’m seeing available is a 3 Duce manifold to upgrade , so what carburetors are best suited for a 10/1...
Hotheads show brackets to use with their short snout set up , however I want to stay with a more classic look with the long snout cover, so I’ve...
I’m hoping I can figure out how to put air and power steering on it while I’m in there, hoping hotheads has all the brackets for that
Separate names with a comma.
The Jalopy Journal
