The Jalopy Journal
I only wish this was going to cost me hundreds! I’ll have around $5k into just the trans and rear axle
I believe that depends on which brakes I choose
Which rear brakes should I go with when I have my rear end upgraded by Hot Rod Works? and why? Here is my car… 41 Ford coupe Y block 200 HP? ♂️...
Still available. Make offer
I found a set of 4.44’s. Thanks everyone!
I’m having a T5 built with a .55 overdrive. So my hope is to have a close ratio hot rod on the street yet it will still be able to cruise down the...
Speedway has some as low as 5.86 but that’s probably too low. Im thinking I need something around 4.30-4.50ish range.
That might be just right! Thanks! Is there a supplier that has a variety of different ratios to choose from?
Where can I find lower gear sets for my 41 Ford banjo rear? The lowest I can find is 4:11
Want to sell one???
Wouldn’t that make it easier to mount up to a torque tube?
I see a lot of info about using the T176 shifter on a 4 speed toploader transmission but does anyone actually use a T176 4 speed transmission in...
He mentioned a few ways to pay and that was the only one I have already. I should have known it was a scam when he didn’t accept PayPal. Ugh! What...
Apple Pay $1280 for a transmission and shipping
Does anyone know the real name, address, or phone number to “Bill Robinson shop” on Facebook? He won’t send the parts that I paid for
I just lost $1280 to this jackhole! Does anyone know his real name, number, or address?
Great! Thanks! Do I tighten the motor mounts the same way???
Thank you
Where do I get the rubber pads for the transmission mount on a 41 Ford coupe? Are they the same as the motor mounts???
Speed Gems response was “You will need the long 3 finger Borg & Beck style. A 10 or 10.5” will work”
Still available…
Alchemy, my new buddy, I now realize that I will need to drill the flywheel for a smaller clutch and that I will need to have the correct throw...
Dang, I didn’t think about having to get a new flywheel for the small clutch’s bolt pattern. Oh well… Does anyone know for sure that a 10 inch...
I’m swapping a 292 y block with a 39 top loader into my 41 Ford coupe and I need advice on what clutch to order. The clutch that came with the...
Turns out they are marked on the back side! [ATTACH]
What year of S-10 and/or engine do I need to look for to find a 4x4 T5 transmission? I would like to modify it to work with the factory torque...
Ok, thanks for you help bud!
[ATTACH]
Alchemy are the front and back bumper guards different or the same?
You’re not helpful
Separate names with a comma.
The Jalopy Journal
