The Jalopy Journal
They would be perfect but my coupe has the one piece seat back. Thanks
Thanks everyone, I found some made for split seat backs but mine has the one piece seat back.
Does anyone know of a source for premade seat covers available for early cars such as a 40 Ford coupe? Thanks!
Thanks for the suggestions.
I need to make new door, kick and rear interior panels for my 40 Ford Coupe. Any suggestions on what backer board to use? Thanks!
Many thanks everyone.
What is a good adhesive to reattach vinyl to backer board? Any and all help appreciated.
I agree.
Has anyone used a mid 80s Thunderbird (front or rear) suspension in any street rod applications? Thanks
Thanks
My nephew borrowed my truck for a few weeks and during that time he ran thru some highway line marking paint and it splattered up on the side of...
Yes on the yoke, I dont understand why it came out easily before and not now. Thanks
Attempting to replace rear seal on my 66 F100 with 3 speed manual trans and the drive shaft refuses to come out. It comes back 1/4 inch and...
Does anyone have any pictures or charts showing the manual trans side plate covers Ford used in their F 100 trucks in the mid 60's? Thanks
Thanks, will try that
Looking for a clutch return spring for a 66 F100, I tried Carpenter, Drake and Rock Auto but no luck, any suggestions? As always, thanks.
Working on Ford in line 6 cyl. with points distributor, the engine started and ran fine one day and wouldn't start the next. I checked the...
Compression checked out good 130 -145 so valves, rings etc good. So what else causes vacuum plugs to blow off? Thanks!
The engine is a 74 Ford 300 inline 6 with a one barrel carb.. Both carb and fuel pump are new aftermarket stock replacements. Going to do a...
When trying to start this engine it runs but raw gas is pushed out the top of the carb and some vacuum plugs are pushed off. Never had this issue...
The pan is only leaking in a 2 inch space on drivers' side, does anyone make an injectable sealer? I tried lowering the pan and stuffing gasket...
Any of you guys had any success in removing the oil pan from a SBC while it was still living in a 40 Foad that still has stock front suspension?...
Thanks for the response, Im going to block the third hole and keep on truckin.
The intake on my 74 Ford 4.9 L (300) has three large holes where the carb bolts to it, two are stud holes any idea what the third hole is for?...
I am working on a 66 F100 that has a 75 300 engine (not running) installed in it. Should I use the original (still installed) 75 HEI distributor...
On a 66 Ford F 100 does the voltage regulator mount to the fender well or radiator support? I am trying to reassemble a project I did not...
Thats what I needed to know, Thanks.
Thanks. good luck with the 36. So, you have no clearance issues with your clutch arm?
With the Nova bell housing, will the clutch arm clear the stock wish bone on a 40 Ford? Thanks
With the clutch arm location at 7:30 does the arm hit the un split wishbone on 1930-40 Ford cars? Thanks!
Separate names with a comma.
The Jalopy Journal
