The Jalopy Journal
I have a 38 ford truck, all original, that’s been running great the last couple of years Yesterday I went to go for a ride & this knocking noise...
Around 140ish in my first car:a 64 impala with a warmed over 283 pg with 3:08 gears. Wasn't smart enough to be scared another time I woke up in...
I specifically am wondering what modifications need to be done to the rear suspension after converting to a open driveshaft
How to install a 5 speed
My opinion would be try the one inch. That's what I use on my chevelle, which has disc in front and drums in back (manual)
Does anybody know where I can locate the grills for a 1941 Ford coupe. I have the main grill, but can't find the grills that are on the bottom...
Do you have to disassemble the engine to install adjustable lifters ?
What's considered normal oil pressure for a 1938 85hp flathead? I have 10psi at idle, goes to 30psi going down the road. A little higher when...
Thanx
I have a set of original shocks for my 1938 ford pickup & have no idea how they mount Any advice or pics? Thanx
I do wanta thank everyone who replied I learned something from everyone It’s running much much better Thanx to All !!!!!
I have jacked the timing until it really rattled entered I just had the carb apart AGAIN & played with those emulsion tubes again (enlarged the...
The transmission isn’t supposed to leak even if the converter drains back You need to fix the point it leaks from (most likely the transmission...
Agree with squirrel points can go pretty good. I went high 10s with points. My buddy was convinced I’d go faster with an MSD, so we stuck...
I did go thru the distributor Starts a little better (I mean the motor doesn’t seem to turn over 1 time before starting) Idle screws have been...
Accelerator pump works good. Carb works perfect, other than just off idle. If I stab the the throttle, runs great but I can't drive it like that...
Help. I have a 1938 21 stud motor that has an off idle hesitation Carb is relatively new, but has been attacked by ethanol. I’ve cleaned it out...
Separate names with a comma.