The Jalopy Journal
First test at bulb socket filament's light switch on and had 12 volts to all contacts. I eliminated sockets and taillight harness by disconnecting...
Checked ohm reading on firewall to tail harness. Brown (taillight) to each yellow and green (brake) No reading on one and a low reading on the other.
I thought it was the turn signal switch until I checked at cab harness. Lights on have power to brown taillight wire NOT yellow and green brake...
First of all I was completely wrong with no brake lights with light switch on. Problem is I have brake lights with light switch on. I disconnected...
I removed dash lights completely with no change. I'm fairly convinced there is not a ground issue or wire short up to turn signal switch. I'm not...
I'm still going to do the wire test and pursue. ground issues. The board is grounded but I will confirm that as it does function correct. Thank...
Ok. First the turn signal switch on column. Key on all turns work as well as brake lights. Key on light switch on. I lose brake lights and only...
Are you referring to the taillight bulbs? I know the first three problems for light problems are ground, ground, and ground. If brake lights and...
I did the test with meter and have no voltage. Replaced bulbs. Same problem. With key on all turn signals and brake lights work. This circuit is...
All my lights are grounded and work fine with key on. That circuit is run through the turn signal switch and all work fine. I lose it when the...
Yes I am. That problem was a ground wire.
All lights work with key on. With light switch on I loose brake lights and only have one side turn signal. Light switch is new. Had problem...
Brake lights work. I did the test for ground with bulbs. Key on left signal on, removed right bulb left bulb stays on. Same thing with right as...
This truck has been sitting in garage several months. The problem occurred after sitting not any driving or wire changes. If the lighting worked...
By the way I want to thank everyone for responding with the help. As far as the ground wire. The housings have a chrome trim molding covering the...
The housings each have a wire connector sandwiched between the housing and body at the mounting screws to the frame. I have to remove the housings...
My front lights are grounded I guess from the screws into the hood. They do work so I assume they are getting ground. My taillights both have a...
I have a no turn signal on a 65 Chevy C10. Out of the blue I lost taillights. Knew I had bulb socket and wiring problems at the lights. I...
Hello, I'm Miles an old school guy in Texas from the 60's. I've always been a DIY, but when it comes to wiring I'm in the learning stage. I have a...
Separate names with a comma.
The Jalopy Journal